- 2K Ceramic Underhood Black Quart Kit
I would like to recoat the factory paint on my 1981 Jeep frame, I do not want to remove the original coat since it was dipped and protects the inside of the boxed frame. Would this be the best product to use?
How fine a grit of sand paper needs to be used to prep for 2k ceramic paint over Clausen All-U-Need?
can 2k ceramic paint go over epoxy primer?
can 2k ceramic urethane paint go over epoxy paint
Can 2k ceramic chassis black be applied directly to rust encapsulator or do you need to use the epoxy primer?
2K Ceramic Underhood Black Quart Kit
Item #11973ZP Brand: Eastwood
- Mix 4:1 with activator included
- Use your HVLP spray gun to apply
- Quart is enough for about 48 square feet
About 2K Ceramic Underhood Black Quart Kit
Eastwood's new 4:1 2-component (2K) Urethane Ceramic Underhood Black is the only Underhood coating fortified with nano-cermaic technology. Nano-ceramic particles ensure the ultimate in durability, chemical resistance and long lasting looks. Eastwood's Underhood Black is the right 10-20% gloss to match that original sheen. For maximum durability apply over Eastwood's Epoxy Primer. To apply mix 4:1 with urethane activator 21854Z and apply using an HVLP spray gun. One quart covers about 48 square feet, depending on number of coats and thickness.
50253ZP 32 fl oz of paint 21854Z 8 fl oz of actvator
10041Z PRE painting prep 51550 Concours HVLP sparay gun 12817 Paint gun accessory kit 50242ZP/50243ZP Epoxy Primer 51482Z Rust converter 11455/11456 respirator 51559 Digital Regulator
To apply, mix 4:1 with the urethane activator included. (Reduction is not necessary, but can be achieved using 50104ZP Zero-VOC Urethane Paint Reducer.) Use an HVLP gun with 1.2-1.5mm nozzle size. Apply in two medium wet coats, allowing 10-15 minutes between each coat. A dry film thickness of 2 mils is recommended. Complete cure time is 24 hours. Pot life is approximately 2 hours.
Keep away from heat sparks and open flame. Avoid prolonged contact with skin and breathing of vapors. Always wear appropriate eye, skin and respiratory protection. Consult MSDS for specific safety instructions and precautions.
Made in USA
To apply mix 4:1 with urethane activator 21854Z Reduction is not necessary, but can be achieved using 50104ZP Urethane reducer Apply in two medium wet coats allowing 10-15 minutes between each coat. A dry film thickness of 2 Mils is recommended, complete sure time is 24 hours. Use an HVLP gun with 1.2-1.5 nozzle size. Pot life is approximatley 2 hours
Customers also viewed:
Nano-ceramics for long-lasting heat resistance; red, silver or black
Starting at: $39.99
Etches and primes bare, rust-free metal in one step
Starting at: $14.99
Restore the original color of metal parts, and protect against rust
Starting at: $14.99