One Year Manufacturer's Defect Warranty.

Designed, engineered and tested to Eastwood's specifications.

• 15KV/25KV dual voltage output
• New and improved ground clamp provides a better ground
• Color coordinated cabling for easier setup
• New clear bottle makes it easy to see powder level and fluidizing action
• Additional 1/2" of trigger room makes it easier and more comfortable to use

Eastwood Powder Coating Videos - CLICK HERE

(Q) How long does the baking process take?
(A) For improved flow out (less "orange peel"), bake coated parts at 500 degreesF until powder flows out (about 3-4 minutes for light sheet metal parts), then turn down the heat to 400 degreesF for a full 15 minutes.

(Q) What are the electrical requirements?
(A) This HotCoat Gun requires 110-125VAC, 2 amps at 50-60 Hz. Can be used with a voltage transformer such as 220-240VAC to 110-125VAC as long as the transformer can handle 2 amps. Ships via UPS

PCS-250 Dual-Voltage HotCoat Powder Coating Gun, dual-voltage power supply, activation switch, ground clamp and cable, and an empty 8-oz. bottle.

Click here to download product instructions

Use a disposable dust mask when handling or applying powder. Powder, like common flour, can be explosive when suspended in the air in high concentrations. To minimize any explosion risk, sweep up—do not vacuum—powder from the floor. Cure powder in a well-ventilated area. The urethane powders we sell liberate a very minute amount of isocyanates when the powder flows out. This usually occurs about 3-5 minutes after the part is placed in the oven to bake. Wear a respirator with fresh filter cartridges when curing or inspecting flow-out progress.

31289 Pancake Compressor
11536 Powder Coating Accessory Kit
High Temperature Masking Tape
Eastwood Hotcoat Powders

Why Powder Coat? What are the Advantages of Powder Coating?

The PCS-250 Dual-Voltage HotCoat gun is one of the best powder coating guns on the market today. Why powder coat? Because it gives you one of the most economical, color-durable and longest-lasting finishes available. You'll find powder coated surfaces are far more resistant to chipping, scratches, fading, and wear than other finishes, and the color selection is virtually unlimited, with high and low gloss, metallic, and clear finishes available. And thanks to the UV resistance of many of the powders, colors stay bright and vibrant longer.

Texture selections range from smooth surfaces to a wrinkled or matte finish, plus rough textures designed for hiding surface imperfections. One 8 oz. bottle of powder (not included) covers the same area as 2-3 cans of spray paint, and clean-up is easy since you can simply sweep-up the over-sprayed powder. This powder can be reused as well if it's not contaminated. Eastwood powders contain no environmentally harmful solvents so you can be planet-conscious as well. HotCoat powder coating requires a 5-10 psi compressed air source and a dedicated electric oven (or toaster oven).

Can I Powder Coat in My Own Garage or Shop?

Owning a dual-voltage electric powder coating gun means you can apply this technique to springs, valve covers, tri-flow radiators, vehicle body panels and anything else that needs a quality finish. One quick-change empty powder bottle is included and you can easily add more. The tool is designed to our exact specifications with a handheld activation switch, air inlet, removable diverter tip and grounding system.

New to powder coating? Our YouTube channel has a large playlist of powder coating videos that how to apply powder to different parts and what other equipment you might need. Our tech team is also available seven days a week by phone or email with free expert advice and solutions. Continue down this page for suggestions on accessories and safety equipment or visit our customer review section. Eastwood has a 100 percent customer satisfaction guarantee on every piece in the HotCoat powder coating system.