Building Door Frames to Match the Chop

    It's been a while since we talked about the roof chop on Pilehouse, but I've been doing a lot of boring work on the smashed up old roof getting it satisfactory. Since then I decided to finally finish building the doors to match the roof. I took some pictures as I did the drivers side to show one way to do it, and I did the passenger side an alternative way to show another way you can tackle this project. We shot the video on the passenger side, but in the photos here you can see the other way to go about it.

    Just like chopping the roof down, we needed to take out some height from the top of the door, split it in half, and add some width to it. That's why it's extremely handy to keep original metal that you cut off of the truck. I started by splitting the top of the door in half so we could mock up the two pieces so that they sat where we wanted them to in the door jamb.

    I started with the rear portion and held it in place in the door opening and closed the door until the post met the top of the door I was holding in place. From there I made a mark on the pillar where the 2 parts overlapped. From there I could cut the excess off of the door. In the front of the door I needed to take the extra material out of the top of the door since that was the straightest part of the upper front portion of the door. If at all possibly you always want to take material out of the pillars, doors, etc where the pieces are straight and the most uniform. Cutting them on a curve makes it VERY difficult to piece things back together smoothly and get your angles correct.

    Once the pieces were cut I temporarily tack welded them to the edge of the roof to get them sitting about where I wanted. With the tack welds I could still adjust the parts without them being permanently mounted. This way I could shut the door and line everything up how I wanted.

    Once the front and rear sections of the door were about where I wanted them I grabbed the piece of the door I cut out of the front. This portion of the door was very close in size to the center and only required minor tweaking to get the backside contours to match up.

    From there I was able to tack weld and adjust everything how I wanted and I could weld the seams all together. On the drivers side I hadn't fully cut and ground the drip rail off so I went about mocking up the door pieces. Either one will work, just be sure to use paint stir sticks or similar as spacers to leave room for seals in the door jam. With the doors welded back together the full effect of chopping the roof is visible. I think this mild chop really made Pilehouse look better. My next plans are to customize the hood and build a custom tailgate, so stay tuned for more updates.

    Leave a Comment