Assembling The Roof- Cleco Panel Clamps Are The Third Hand

The entire process of chopping the roof on a vehicle is quite long. Along the way there are a lot of tricks and tools that will make your life a lot easier; especially if you work alone. Since I wanted to keep my A-pillars in the stock configuration I had to make a filler panel to fill the gap between the front and rear half of the roof. The filler panel runs the width of the roof and it's pretty tough to hold this in place by myself as I test fit it. I found that it was much easier to hold one end in place, drill a small 1/8" hole and insert a cleco every few inches. This pulls the panel in place and I can manipulate my panel to fit exactly how I want. This also allows me to stand back and visualize how the final profile of the roof will look. Once you have a pack of clecos in your toolbox you'll wonder how you worked with out them! Check out our selection of blind panel grips here: Cleco Blind Panel Clamps

Leave a Comment