Tag Archives: pro flare tool

  • Plumbing Custom Brake Lines on Project Pile House

    First of all, if you're rebuilding an old car, whether it's a full blown 100 point restoration, or an out-of-this-world kustom, you shouldn't forget about completely redoing the brakes on your ride. Brakes are one of the most overlooked part of a build that can save your car and your life. Project Pile House is a full blown custom with little to be left original on the truck. It sits on a first generation Chevy S10 chassis, so the brake components on each corner are easy to get replacements for, but that's about where it stops being easy. I recently decided to plumb the brake system on Pile House, and show you what goes into a project like this.  Click Here To Read Full Post...
  • Tips and Tricks to Flare your own brake lines

    The brake system in a modern car is very complex, but when you break it all down they all work the same. The simplest description is that the brake pedal is depressed which compresses a piston in the master cylinder creating hydraulic pressure that sends fluid to each corner of the vehicle and activating the brakes. The system MUST be air tight and free of any contaminates or air bubbles. The sealed connection at each brake fitting is made by tightening a brake line and fitting into an opening that is shaped the opposite of the flare. Once tightened, an air and fluid tight connection is made.  Click Here To Read Full Post...