- Calyx Manifold Coating 3 oz
- Rub-in with rag or toothbrush
- No disassembly required
- Enough for 8-10 typical V8 exhaust manifolds
About Calyx Manifold Coating 3 oz
Though it's not as durable as our paint on coatings, it is convenient and easy to apply because there's no disassembly required. Just remove loose rust and rub-in thoroughly. Non-toxic and water-soluble. A little goes a long way: one container treats 8-10 typical V8 exhaust manifolds. Made in USA.
For the best results, manifold should be removed, abrasive-blasted, and wiped down with PRE Painting Prep (10041Z) before applying. If you wish to apply Calyx while the manifolds remain installed on the engine, use a wire brush to remove surface rust and dirt, then wipe down with PRE. Apply Calyx with a rag or toothbrush, and work it into the pores of the metal. For a buffed appearance, use a fingernail brush.
3-oz. container of Calyx Manifold Dressing, with instructions
10041Z PRE Painting Prep, Aerosol
Customers also viewed:
The right viscosity to spray-paint your radiator without damageOnly $14.99
Original long-lasting formula resists chips, corrosion, temps to 300°FOnly $14.99
Withstands up to 600 degreesF to protect exhaust componentsOnly $12.99