Ceramic Engine Paint Old Ford Blue Qt

Item #777 51682ZP Brand: Eastwood

Ceramic nano-technology engine
enamel withstands 650°F

Details

Eastwood sets the standard in high temp engine paints!
  • Super durable, utilizing ceramic nanotechnology
  • Protects engine and resists chips, chemicals and heat
  • Withstands temperatures up to 650 F
  • Provides a beautiful factory-look finish
  • Easy to apply – brush or spray on (for best results metallic’s should be sprayed)
  • One quart covers approx. 40 square feet
  • For added durability and gloss use Eastwood's activator 21854Z

About Ceramic Engine Paint Old Ford Blue Qt

Eastwood's Ceramic Engine Enamels provide a beautiful factory look finish that is super-durable and will withstand temperatures up to 650³ F. Developed using the latest ceramic nano-technology integrated with silicone alkyds, this is the new standard in engine coatings. Each color is replicated after the original color for that deep rich factory look. The ceramic nano-technology ensures that your motor will be protected and resist small chips, chemicals and heat. In fact this is the highest temperature range in the industry, 650³ F! NOT FOR USE ON EXHAUST MANIFOLDS OR HEADERS


Contents

32 Fluid Ounces


Accessories

Eastwood offer a wide variety of underhood and undercart coatings. Exhaust manifold Paints Underhood black 10024z 10032z Spray Gray, 10109Z Aluma-Blast, 10036z Detail Gray PRE 10041z & 10194zp Underhood detailing kit 10426z Long term engine storage bag kit 50470 Engine rebuilding tools and installation equipment


Safety

Always wear eye, skin and respiratory protection. Consult MSDS for specific safety precautions. Always use in a well ventilated area.


Warranty

Made in the USA


Application

To apply simply clean all surfaces with PRE (10041Z or 10194ZP) to remove all oils and greases, apply Ceramic Coating using a brush or spray gun. Two coats may be needed for full coverage. Some reduction up to 10%, may be needed to spray, use EW reducer 50104ZP. No primer is necessary and allow 24 hours to fully cure NOT FOR USE ON EXHAUST MANIFOLDS OR HEADERS


Customers also viewed: