Eastwood Original Chassis Black Aerosol Satin and Gloss
- Surface must be clean and dry before painting. Use Eastwood PRE Painting Prep (10041Z) to remove grease and oil. Can be used on bare metal, or over primer. For increased adhesion and durability, prime clean, bare metal with Extreme Chassis Black® Primer. Prime firmly adhering rust with Eastwood Rust Encapsulator™, wait 15 minutes to 36 hours (scuff surface beyond 36 hours with 320 grit) topcoat with Chassis Black®. Do not use over self-etching primers. Test for compatibility if not using over Extreme Chassis Black® Primer or Eastwood Rust Encapsulator™. For best results, use when can is between 70 degrees and 90 degrees F (21 degrees and 32 degrees C), 50% or less humidity.
- SHAKE CAN VIGOROUSLY for at least one minute before and occasionally during use. Spray surface with steady, even strokes at a distance of 8 to 10 inches. Several light coats give a better finish then one heavy coat.
- Apply enough paint to achieve full hiding. For faster cure, apply a maximum of 2 coats primer and 2 coats Chassis Black. Allow 24 hours between coats.
- If clogging develops, turn spray button ¼ turn or remove and clean spray button slot. DO NOT stick objects into can opening.
- Finished article should be allowed to dry 48-72 hours before use.
- After painting turn can upside down and spray for 2 seconds to clean spray button.
- Do not incinerate or compact empty can.
Eastwood Original Chassis Black® Quart Satin and Gloss
- Surface must be clean and dry before painting. Use Eastwood PRE Painting Prep (10041Z) to remove residual grease and oil. Can be used on bare metal, or over primer. For increased adhesion and durability, prime clean, bare metal with Extreme Chassis Black® Primer. Prime firmly adhering rust with Eastwood Rust Encapsulator™, wait 15 minutes to 36 hours (scuff surface beyond 36 hours with 320 grit) topcoat with Chassis Black®. Do not use over self-etching primers. Test for compatibility if not using over Extreme Chassis Black® Primer or Eastwood Rust Encapsulator™. For best results, use when can is between 70 degrees and 90 degrees F (21 degrees and 32 degrees C), 50% or less humidity.
- Stir for at least one minute before use.
- For Spray-on Application: Several light coats give a better finish then one heavy coat. Contents are thinned to sprayable consistency. If desired, further thin with Toluol or Xylol. Apply enough paint to achieve full hiding. For faster cure, apply a maximum of 2 coats primer and 2 coats Chassis Black. Allow 24 hours between coats.
- Finished article should be allowed to dry 48-72 hours before being handled.