Details

About Eastwood 100-lb. Pressure Abrasive Blaster

Built for the professional, with a sturdy welded hopper, 1/2" heavy-duty nozzle, heavy-wall blast hose and safety pressure-relief valve, so it's rugged, durable, and very efficient. Don't skimp with one of those low-cost units that frustrate you with clogging and sporadic media spraying. This Eastwood pressure blaster completely strips the average frame in less than a day, rather than weeks using other units or methods. Designed for high flow with minimal air input; a compressor producing a minimum of 10cfm at 90psi will work fine. 18.5"H x 12"W.

Rolls easily to your job site. For best results and the most efficient operation, use clean, dry, 80-grit or finer abrasive media. 1-year limited warranty.

100-lb.-capacity Blaster (30-60 minutes of blasting)
Blast Hood
Moisture Separator
1/2"-ID x 8'-long Hose
4 Ceramic Nozzles (2.0, 2.5, 3.0 and 5mm)

WARNING: Blasting emits abrasive under pressure. Adequate respiratory, eye, and body protection must be worn during use. Inhalation of silica-based media particles have been known to cause cancer and other deadly diseases, and must be avoided. Wear NIOSH- approved respiratory protection while operating this equipment.