- EW 200lb Pressure Abrasive Blaster
EW 200lb Pressure Abrasive Blaster
Item #51119 Brand: Eastwood
Huge 200-lb. "High-Flow" Pressure Blaster helps you remove rust and paint faster
- Extra-large 200-lb. media capacity
- Large 1/2"-I.D. blaster hose and fittings
- 8'-long, heavy-wall blast hose with deadman valve
- 4 ceramic nozzles included
- All-steel welded top-loading hopper and pressure gauge
- Requires just 10 cfm at 90 psi
Bigger is better, both in media capacity and blasting volume! Eastwood's 200-lb.-capacity, "High-Flow" Pressure Blaster features high-volume, extra-large valves, which means more air volume and more abrasive flow for faster removal of rust and paint.
About EW 200lb Pressure Abrasive Blaster
Just connect to a compressor, put on appropriate hood and respiratory protection, fill with abrasive and blast. Built for the professional, with a sturdy welded hopper, 1/2" heavy-duty nozzle, heavy-wall blast hose and safety pressure-relief valve, so it's rugged, durable, and very efficient. Don't skimp with one of those low-cost units that frustrate you with clogging and sporadic media spraying. This Eastwood pressure blaster completely strips the average frame in less than a day, rather than weeks using other units or methods. Designed for high flow with minimal air input; a compressor producing a minimum of 10 cfm at 90 psi will work fine.
Rolls easily to your job site. For best results and the most efficient operation, use clean, dry, 80-grit or finer abrasive media. 1-year limited warranty.
200-lb.-capacity Blaster (60-120 minutes of blasting)
1/2"-ID x 8'-long Hose
4 Ceramic Nozzles (2.0, 2.5, 3.0 and 5.0mm)
WARNING: Blasting emits abrasive under pressure. Adequate respiratory, eye, and body protection must be worn during use. Inhalation of silica-based media particles have been known to cause cancer and other deadly diseases, and must be avoided. Wear NIOSH- approved respiratory protection while operating this equipment.
Customers also viewed:
Switch "on the fly" between soda and abrasive media...or combine!
100-lb. blaster has large, high-flow valves to speed rust/paint removal
50-lb. blaster has large, high-flow valves to speed rust/paint removalOnly $119.99
Easiest way to neatly pour abrasive into a blaster; also filters debrisOnly $15.79
USA-made 2-in-1 blaster works with as little as 10 cfm at 90 psiOnly $699.99
2-in-1 blaster works with as little as 10 cfm at 90 psi
An affordable way to media blast parts without taking up much room in your shop