• Home
  • Eastwood Pinup Red Basecoat Gallon 54222

Can I get any quanity smaller than a gallon?

Asked by: Ford lover
Our Single Stage Urethane paints are currently only available in gallon kits.
Answered by: MikeL
Date published: 2014-09-30
  • 2015-03-05T11:52CST
  • bvseo_cps, prod_bvqa, vn_cps_3.1.1
  • cp_1, bvpage1
  • co_hasquestionsanswers, tq_1
  • loc_en_US, sid_54222ZP, PRD, sort_recentAnswersFirst
  • clientName_eastwood

Eastwood Pinup Red Basecoat Gallon 54222

Item #54222ZP

Apply a durable urethane finish


Pinup Red Basecoat adds the superior durability of urethane to the ease of conventional basecoats Pinup Red Basecoat Kit is a low-VOC system, so it meets regulatory limits in highly-regulated areas, eliminating the need to switch to a waterborne system.
  • Apply a durable urethane finish wherever you live in the continental US, even CA
  • Choose a fast, medium or slow Low-VOC Activator below
  • Mixes 4:1 with your activator choice

More info...

About Eastwood Pinup Red Basecoat Gallon 54222

Eastwood's innovative Urethane Basecoat Paint System combines the ease of use of conventional basecoats with the superior durability and unmatched performance of more modern urethanes. And because it's a Low VOC system, it meets regulatory limits in highly regulated areas, eliminating the need to switch to a waterborne system. If you combine the basecoat system with our new finish to any car, anywhere in the continental U.S. Mixes 4:1 with Eastwood's Low VOC Urethane Activator


One US Gallon of paint, 128 Fl. Oz, one quart of activator (Choice of slow, medium or Fast)


SAS Bandit Respirator
1/4” Digital Regulator
Gray Urethane Primer Surfacer
1.7mm Needle/Nozzle Set
Low VOC Clear Gallon Kit
Evolution gun stand
Pre Painting Prep Aerosol
Concours Paint Gun
Liquid Ice Finishing System


Always wear eye, skin and respiratory protection. Always paint in a well ventilated area. Consult MSDS and Tech Data sheets for proper safety precautions

Product Information Sheet

Click here for product instructions


Prep surface and remove all traces of contaminants. Use Eastwood's PRE Prep. Sand existing finish with 400 to 600 grit abrasive. Reclean surface. Mix 4:1 with activator. Reduction not necessary. Shake Well. HVLP Gun Nozzle Size 1.2mm to 1.4mm. Apply in 2 medium wet coats with 50% overlap. Allow 10 minutes flash time between each coat. Clear coat can be applied after 20 to 30 minutes. Maximum recoat time is 18 hours. Otherwise surface must abraded with 400 to 600 grit. Use 50307ZP Low VOC Clear & Activator Pot life is about 2 hours at 70°F Application