• Home
  • Eastwood Rat Rod Gray Paint

Eastwood Rat Rod Gray Paint

Item #51073 ZP Rat Rod Gray

Premium acrylic urethane topcoat for exceptional long-lasting beauty

Details

Eastwood's premium Rat Rod Gray Single-Stage Acrylic Urethane Topcoat provides exceptional long-lasting beauty and durability.

Some project rods just won't look finished until you've put on that distinctive, flat car paint finish. Our Rat Rod paint is the only way to go! This premium 2-component topcoat system is blended with top-quality raw materials and advanced composition coatings technology. Superior to acrylic, alkyd and lacquer coatings. Eastwood's single-stage urethane paints hold their gloss longer and won't yellow.

  • 96-oz. Rat Rod Gray Automotive Paint
  • 32-fl.-oz. Activator required (included in 51073ZP Kit)
  • Catalyzed urethane for unsurpassed durability
  • Highly resistant to UV rays, chemicals, chips

About Eastwood Rat Rod Gray Paint

Sure, some like to "drive her in primer", or opt for a quick "rattle-can" paint job, but this activated, single-step acrylic urethane Rat Rod car paint is a smarter and much longer-lasting choice! Mix 3:1 with activator; no further reduction required.

Not for sale or use in California. Eastwood Paints are formulated to meet National Rule VOC regulations; check with your local and state guidelines as some areas may have stricter regulations than others.

Due to regulations pertaining to recycling, we are unable to ship this product to Alberta, Canada.


Contents

Choose from the following:
51073ZPKIT is the Rat Rod Gray Single-Stage Urethane Topcoat, Gallon, with Activator; enough to coat the outside of most cars
51073ZP is the Rat Rod Gray Topcoat, Gallon, without Activator
21856ZP is the Eastwood Urethane Activator, 32-oz.


Application

Clean surfaces of all contaminants. Abrade surface to be painted with a minimum of 320-grit sandpaper, working up to a 600-grit for maximum adhesion. Re-clean surface. After shaking paint, mix 3 parts paint with 1 part activator. Use caution mixing materials as paint may begin to gel after 2 hours at 70°F. HVLP gun setting: 8-10 PSI, with a 1.4mm-1.8mm tip. This color is formulated to give complete coverage in 2-3 coats. Allow 10 minutes flash time between coats; should be tack-free in 45-60 minutes, with full cure in 18 hours.


Accessories

10194ZP PRE Painting Prep, Quart
51605 Concours HVLP Paint Gun Kit
51686 Concours HVLP Detail Gun
20474 4-Stage Dry Air System
50040ZP Master Paint Prep Kit
51561Z 6" Liquid Ice Buffing Kit
34053 Hobby Air Fresh-Air System
51559 Digital Regulator
50244ZP Epoxy Gray Primer, Gallon
50245ZP Epoxy Primer Catalyst, Gallon
50240ZP 2K Urethane Gray Primer, Gallon
50241ZP 2K Urethane Primer Catalyst, Quart


FAQs

(Q) How much paint do I need?
(A) Typically one gallon per car. If you are also painting jambs, under the hood, or the trunk, use 2 gallons. For large cars and pickup trucks, use 2 gallons. Number of coats, prep and application methods will affect the amount of paint required.


Safety

Always wear proper eye, skin and respiratory protection. Always paint in a well-ventilated area away from sparks and open flame. Consult MSDS and product data sheets for proper safety precautions.


Product Information Sheet

Click here to view product information sheet


Customers also viewed: