- Eastwood Rubberized Rust Encapsulator Undercoating - Black
Eastwood Rubberized Rust Encapsulator Undercoating - Black
Item #13651 Z Rubberized Encapsulator
Eastwood's Rubberized Rust Encapsulator is the flexible version of our high-performance Rust Encapsulator coating that applies directly over rust or bare metal to provide long-term corrosion protection.
- Flexible finish protects surfaces from abrasions, and deadens sound
- Epoxy-fortified for better adhesion and durability
- Withstands up to 250°F
- One aerosol covers about 10 square feet
About Eastwood Rubberized Rust Encapsulator Undercoating - Black
Unlike off-the-shelf under coatings, Rubberized Rust Encapsulator can be applied directly over rust and without the “bubbling” that creates air pockets thus trapping rust. Since its engineered with high-tech flex agents, its pliable finish protects surfaces from abrasions, road hazards and deadens sound. So durable it exceeded 1,000 hours of salt spray chamber testing, this surpasses the standards for a 2-component catalyzed coating! Simply apply directly over rust or bare metal; no need to topcoat. Remains flexible and durable. Satin black finish.
The quart is not for sale or use in California. Eastwood Paints are formulated to meet National Rule VOC regulations, check with your local and state guidelines as some areas may have stricter regulations than others.
Choose from the following:
13651Z is the Eastwood Rubberized Rust Encapsulator, Black, Aerosol
11864ZP is the Eastwood Rubberized Rust Encapsulator, Black, 1-qt. Can
Aerosol also available in a 12-pack.
10041Z PRE Painting Prep
16060Z Rust Encapsulator
51483Z Rust Converter, Aerosol
12515Z Internal Frame Coating
11175Z Extreme Chassis Black
10025Z Original Chassis Black
10020Z Silver Exhaust System Paint
Use a wire brush to remove loose rust, scale and paint, and remove dust, grease and oil deposits. Feather surrounding paint with 220-grit sandpaper. Shake can for at least 2 minutes once the mixing ball starts to rattle. Hold the Rubberized Rust Encapsulator can 10"-12" above surface as you spray. A single coat dries to the touch in 20 minutes, and is thoroughly dry in 3-4 hours at 68°F. For greater durability, a second coat can be applied 1 hour after the first. Allow 6-8 hours after the last coat before applying topcoat (no need to topcoat, unless desired). Quart may be brushed on or applied with an undercoating gun (like our 20441 Undercoating Gun Kit).
Always wear eye, skin and respiratory protection. Always apply in a well-ventilated area away from open flame.
Customers also viewed:
Stop rust in its tracks!
Starting at: $1.94
Transforms surface rust into a paintable surface!
Starting at: $19.99
Stop rust in its tracks, then seal cracks, crevices and body seamsOnly $54.99
High-grade patina preserving coat prevents further discoloration and protects surfaces from corrosionOnly $19.99
Apply a textured finish that stops—and hides—surface rustOnly $19.99