• Home
  • Engine Paint Kit

Engine Paint Kit

Item #13473 ZP

2K ceramic engine paint, cups,
lids, foam brushes, absorbent mats
Not for sale or use in California. Eastwood Paints are formulated to meet National Rule VOC regulations; check with your local and state guidelines as some areas may have stricter regulations than others.

Details

Everything you need to paint your motor with Eastwood's 2K Ceramic Engine paint is included in this kit. These super durable engine paints are fortified with nano-ceramic particles that will withstand temperatures of up to 650°F. Each color was painstakingly researched to match the original factory color. And the urethane based paints can be brushed on or applied with a spray gun. And the urethane based paints can be brushed on or applied with a spray gun. cups & lids, 3 foam brushes and 15 absorbent Pig Mats so you keep the surrounding area and floor clean.

About Engine Paint Kit

Everything you need to paint your motor with Eastwood's 2K Ceramic Engine paint is included in this kit. These super durable engine paints are fortified with nano-ceramic particles that will withstand temperatures of up to 650°F.Each color was painstakingly researched to match the original factory color.And the urethane based paints can be brushed on or applied with a spray gun.And the urethane based paints can be brushed on or applied with a spray gun.cups & lids, 3 foam brushes and 15 absorbent Pig Mats so you keep the surrounding area and floor clean.

Not for sale or use in California. Eastwood Paints are formulated to meet National Rule VOC regulations; check with your local and state guidelines as some areas may have stricter regulations than others.


Contents

1 Quart of Ceramic Engine Paint
4 Ounces of urethane activator (21854z)
5 One Pint Mixing cups & lids (51201)
3 Foam Brushes (34152)
15 Sheets of Pig Mat Absorbent mats (12461)


Accessories

51686 Concours Detail Spray Gun10041z PRE Painting Prep12196z Chassis Kleen20473 2 stage desiccant dryer


Application

Ensure surface are is clean, dry and free of grease, oils and contaminants.For best results and a consistent finish paint all components at the same time. Mix 4:1, 4 parts paint and 1 part activator. Pot life is about 90 min.Apply in two medium wet coats, allowing 20 minutes between each coat.Allow to fully cure in 24 hours. Safe remaining paint for touch ups or other underhood components. Can be brushed on or applied with an HVLP Paint Gun. Reduction is not necessary, but if desired use a urethane reducer.


Customers also viewed: