• Home
  • Eastwood Ceramic Engine Paint - Quart AMC Metallic Blue

Eastwood Ceramic Engine Paint - Quart AMC Metallic Blue

Item #777 51615ZP Brand: Eastwood

Hi-temp. paint with ceramic
nanotechnology protects up to 650 degrees F


Eastwood sets the standard in high temp engine paints!
  • Super durable, utilizing ceramic nanotechnology
  • Protects engine and resists chips, chemicals and heat
  • Withstands temperatures up to 650 F
  • Provides a beautiful metallic factory-look finish
  • Easy to apply – brush or spray on (for best results metallics should be sprayed)
  • One quart covers approx. 40 square feet
  • For added durability and gloss use Eastwood's activator 21854Z

More info...

About Eastwood Ceramic Engine Paint - Quart AMC Metallic Blue

Eastwood's Ceramic Engine Enamels provide a beautiful factory look finish that is super-durable and will withstand temperatures up to 650 degrees F. Developed using the latest ceramic nano-technology integrated with silicone alkyds, this is the new standard in engine coatings. Each color is replicated after the original color for that deep rich factory look. The ceramic nano-technology ensures that your motor will be protected and resist small chips, chemicals and heat. In fact this is the highest temperature range in the industry, 650 degrees F! NOT FOR USE ON EXHAUST MANIFOLDS OR HEADERS

Not for sale or use in California. Eastwood Paints are formulated to meet National Rule VOC regulations; check with your local and state guidelines as some areas may have stricter regulations than others.


32 Fluid Ounces 1 US Quart


Eastwood offer a wide variety of underhood and undercart coatings. Exhaust manifold Paints Underhood black 10024z 10032z Spray Gray, 10109Z Aluma-Blast, 10036z Detail Gray PRE 10041z & 10194zp Underhood detailing kit 10426z Long term engine storage bag kit 50470 Engine rebuilding tools and installation equipment


Click here for product information sheet


Always wear eye, skin and respiratory protection. Consult MSDS sheet for specific safety information. Always use in a well ventilated area.


Made in USA


To apply simply clean all surfaces with PRE (10041Z or 10194ZP) to remove all oils and greases, apply Ceramic Coating using a brush or spray gun. Two coats may be needed for full coverage. Some reduction up to 10%, may be needed to spray, use EW reducer 50104ZP. No primer is necessary and allow 24 hours to fully cure NOT FOR USE ON EXHAUST MANIFOLDS OR HEADERS

Customers also viewed: