Details

About Eastwood Chassis Black Paint Satin Aerosol 14 oz

Covers fast, with up to four times the coverage of similar size aerosols; cover an entire chassis with just 3-5 cans! (Also available in quarts to cover up to 40 sq. ft.; see 10043ZP Chassis Black® Paint Satin (Qt.).) Applies smoothly over bare metal, Eastwood Rust Encapsulator, or Eastwood Chassis Black Primer. (Not for use over self-etching primers.) 30-day Eastwood warranty.

Due to regulations pertaining to paint recycling, at this time we are unable to ship this product to Alberta, Canada.

14-oz. can with high-solids content provides about 8 sq. ft. of coverage.

Always wear eye, skin and respiratory protection when painting. Follow label directions and consult MSDS for specific warnings.

Eastwood’s Original Chassis Black is formulated to provide you with the right sheen, durability and long lasting great looks. Its 85% gloss level is correct for many factory restorations or use in a custom application. Ideal for frames, suspension components, roll bars, differentials, floor boards and much more. Fortified with high solids and epoxy, Chassis Black resists chips, UV rays and high temperatures up to 300°F. One aerosol can covers approximately 8 square feet.

• *Perfect for a factory or custom finish
• *Fortified with epoxy for durability
• *Resists temperatures up to 300°F
• *One can cover approximately 8 Sq. Ft

Directions

READ ALL INSTRUCTIONS BEFORE USING
1. Ensure surface is clean and free of debris, greases and oils. Use Eastwood’s Chassis Kleen™ and/or PRE™ to remove stubborn grime and prepare the surface for painting.
2. Chassis Black can be applied over bare metal or old paint. To ensure good adhesion, scuff the old paint with 320 grit abrasive. For the best adhesion apply Eastwood’s Extreme Chassis Black Primer prior to painting. DO NOT USE OVER SELF-ETCHING PRIMERS. Test compatibility on a non-descript area before painting.
3. SHAKE CAN VIGOROUSLY FOR AT LEAST ONE MINUTE. Apply to surface with steady strokes about 8-10 inches from surface. It’s better to apply several light coats than one heavy coat. Ideal conditions are 70°F to 90F° at 50% (or less) humidity. Conditions will affect dry times.
4. Apply several light coats until hiding is achieved. Allow at 15-20 minutes between each coat. Full cure time is 24-36 hours depending on conditions. If re-coating after 36 hours, scuff surface with 320 grit abrasive.