• Home
  • Eastwood Chop Top Silver Metallic 3:1 Urethane Enamel

Eastwood Chop Top Silver Metallic 3:1 Urethane Enamel

Item #50211ZP

Premium true acrylic urethane topcoat;
exceptional long-lasting beauty
Not for sale or use in California. Eastwood Paints are formulated to meet National Rule VOC regulations, check with your local and state guidelines as some areas may have stricter regulations than others.
Now available in a Low VOC formula that can ship to California, order item 13564ZP

Details

  • Superior to lacquer, alkyd, and other acrylic topcoats

About Eastwood Chop Top Silver Metallic 3:1 Urethane Enamel

EW Chop Top Silver Metallic is a premium acrylic urethane topcoat that provides exceptional long-lasting beauty and durability. This premium two component topcoat system is blended with top-quality raw materials and advanced composition coatings technology. Superior to acrylic, alkyd and lacquer coatings, a catalyzed urethane system offers unsurpassed durability and resistance to UV exposure, chemicals and annoying stone chips. Eastwood's line of paints will hold their gloss longer and won't yellow. 96 Fl. Oz 3:1 Single stage Topcoat system, requires 21856ZP activator


Application

Clean surfaces of all contaminants. Abrade surface to be painted with a minimum of 320 grit sandpaper working up to a 600 grit for maximum adhesion. Re-clean surface. After shaking paint, mix 3 parts paint with 1 part activator. Use caution mixing materials as paint may begin to gel after 2 hours at 70ø. HVLP gun setting 8-10psi 1.4-1.8mm tip. Eastwood paint is designed to give complete coverage in 2 coats. Allow 10 minutes flash time between coats, should be tack free in 45-60 minutes, full cure in 18 hours.


Accessories

21856 ZP activator required. 50250 ZP Urethane Clear and 50251 ZP Activator 50240 ZP Urethane primer and 50241 ZP Activator 12817 Paint accessory kit, 19830 Respirator, 20406 coveralls 12454Z Block sanding kit, 20491 3-gun set 20472 Air management system


MSDS Sheet

Click Here for Material Safety Data Sheet


Application

Clean surfaces of all contaminants. Abrade surface to be painted with a minimum of 320 grit sandpaper working up to a 600 grit for maximum adhesion. Re-clean surface. After shaking paint, mix 3 parts paint with 1 part activator. Use caution mixing materials as paint may begin to gel after 2 hours at 70Ö. HVLP gun setting 8-10psi 1.4-1.8mm tip. Eastwood paint is designed to give complete coverage in 2 coats. Allow 10 minutes flash time between coats, should be tack free in 45-60 minutes, full cure in 18 hours.


Customers also viewed: