- EW Contour Glazing Putty 24 oz Tube
EW Contour Glazing Putty 24 oz Tube
polyester putty...even on large areas
Fill pinholes and sand scratches with our Polyester Glazing Putty...even on large areas.
- Fills pinholes
- Sands scratches and imperfections
- Can be applied to large areas without distortion
- Mix with other body fillers
Before painting, use this glazing putty to fill pinholes and sand other minor imperfections that can ruin the look of your final finish. Use over sanded substrates, steel and galvanized steel.
About EW Contour Glazing Putty 24 oz Tube
Eastwoodâ€™s Polyester Glazing Putty is designed to fill pinholes, sanding scratches and minor imprecations prior to painting. Unlike other glazing putties, it can be spread over larger areas and fill imperfections without distorting contours. Easily spreads very thin and can be sanded to an ultra thin featheredge. Use over sanded substrates, steel and galvanized steel. Can also be mixed with body fillers to improve their spreading and sanding ability. Includes 1oz cream hardener
Glaze: 24 Fl Ounces/ 710mL Hardener: 1 oz/ 28g
12416z Eastwood Guide Coat 10041Z PRE Painting Prep 13919 Eastwood Filler Spreaders 31273 Eastwood Filler Mixing Board 31160 Dura Block Sanding Boards 21538 Larry Lyles Body Work DVD 12776 Evolution HVLP Paint Gun 14064 2oz cream hardener
Thoroughly mix desired amount of material with cream hardener. Using a clean spreader, fill to desired level. Do not exceed 1/16" depth. Allow to cure for at least 15 minutes before sanding. Abrade with 80-grit and follow up with 120-180-grit to achieve desired contour. Final finish with finer abrasives. Topcoat with quality primer, such as Eastwood’s Epoxy or Urethane Primers.
CAUTION: Do NOT return catalyzed material back into can. To avoid contamination, seal lid tightly after each use. Store in a cool dry place.
Always wear eye, skin and resp[oratory protection when using this product always apply in a well ventilated area. consult MSDS and product label for specific safety warnings
Made in Canada to Eastwood's strict specifications and quality standards
Surface must be clean and free of wax, grease and debris. Abrade surface using 36 grit, or finer. Thoroughly mix desired amount of material with 2% cream hardener. Do not exceed 1/4" depth. Allow to cure 15 min before sanding. Abrade with 120-180 grit to desired contour. Use a finer abrasive to achieve finer finish If necessary, apply Eastwoodâ€™s Polyester Glazing Putty (13521zp) final finishing. Topcoat with quality primer such as Eastwoodâ€™s Epoxy or Urethane Primers. Do NOT return catalyzed material back into can.
Questions & Answers
Customers also viewed:
Save clean-up time, money: 100 tear- off mixing sheets on masonite board
Sands all types of flat and contoured surfaces; use wet or dry
Stronger-than-it-looks portable stand holds up to 750 lbs.!Only $24.99