- Eastwood Contour Polyester Primer Surfacer Gal
Eastwood Contour Polyester Primer Surfacer Gal
excellent base for any paint system
Contour™ Sprayable High-Build Primer/Surfacer serves as an excellent base for any paint system
- High-Build With Excellent Filling Capabilities
- Easy To Sand With No Shrinkage
- Excellent Adhesion To Metals, Fiberglass, and Body Fillers
- Includes hardener
2-component polyester primer/surfacer has excellent filling characteristics and superior adhesion to steel, aluminum, fiberglass, SMC, OE finishes, self-etching primers and body fillers.
About Eastwood Contour Polyester Primer Surfacer Gal
Eastwood Sprayable Polyester Primer-Surfacer is a 2-component high build sprayable body filler that serves as an excellent base for any paint system. It has excellent filling characteristics and superior adhesion to steel, aluminum, fiberglass, SMC, OE Finishes, self Etching Primers and body fillers. Its high solids and high build formula allows you to achieve a laser straight surface prior to painting. Includes catalyst.
Primer: 128 Fl Ounces/ 3.78 L Catalyst: 7 oz/ 210g
12416z Eastwood Guide Coat 10041Z PRE Painting Prep 13919 Eastwood Filler Spreaders 31273 Eastwood Filler Mixing Board 31160 Dura Block Sanding Boards 21538 Larry Lyles Body Work DVD 43579 DA Orbiting Sander 43120 Eastwood Work-Fender Stand
Apply two or three medium wet coats as needed. Heavy wet coats should NOT be applied. Dry spray may be removed before recoating. Allow 90 minutes dry time before sanding at 68 degreesF. Finish with 220-grit, followed by 320-400-grit.
CAUTION: Do NOT return catalyzed material back into can. To avoid contamination, seal lid tightly after each use. Store in a cool dry place.
Always wear eye, skin and resp[oratory protection when using this product always apply in a well ventilated area. consult MSDS and product label for specific safety warnings
Made in Canada to Eastwood's strict specifications and quality standards
Surface must be clean and free of wax, grease and debris. Body Filler & Putty: Rough sand w/80 grit, then 180-220, featheredge w/320 Painted Surfaces: Sand and featheredge using 80, 180 ,220 and finish w/320 Gun requirements: 1.8mm to 2.5mm Fluid Tip Size, 35 to 45 PSI Apply 2-3 medium wet coats. 90 min dry time @ 68Â°F finish with 220 and final with 320-400 grit.
Questions & Answers
Customers also viewed:
Precision of a 2-component coating without the paint gun
Starting at: $21.99
2K Aerospray™ High Build Urethane Primer Gray
Starting at: $22.99
Maintains good color hold-out on steel, aluminum, fiberglass, body fillers
Starting at: $17.99
Sprayable high-build filler is an excellent base for any paint system
Starting at: $8.99
6 foam sanding blocks with different hardnesses and profilesOnly $24.99
Sands all types of flat and contoured surfaces; use wet or dryOnly $59.99