- Eastwood Contour Premium Body Filler .8 gal
Eastwood Contour Premium Body Filler .8 gal
and self-etches, to save you time
- Rust inhibitors prevent corrosion
- Self-etching properties create excellent adhesion
- Superior coverage and feather-edging ability
- 1-step process; no glazing putty required
Due to regulations pertaining to recycling, we are unable to ship this product to Alberta, Canada.
About Eastwood Contour Premium Body Filler .8 gal
Eastwoodâ€™s custom blended Premium Body Filler contains Rust Inhibitors to prevent corrosion long after paint has been applied. Its unique Self-Etching properties bite into the surface for excellent adhesion. This unique formula spreads and sand beautifully thus eliminating pinholes. Furthermore, its excellent featheredging properties wonâ€™t clog up sandpaper. This premium Body Filler is a true one-step application as no glazing putties are required. Includes hardener
Filler 102.4 oz /08 US gallon/ 3 liters Hardner: 2.75 oz/.78g
13521 ZP EW Contour Glazing Putty 10041Z PRE Painting Prep 13919 Eastwood Filler Spreaders 31273 Eastwood Filler Mixing Board 31160 Dura Block Sanding Boards 21538 Larry Lyles Body Work DVD 43579 DA Orbiting Sander 43120 Eastwood Work-Fender Stand
Thoroughly mix desired amount of material with cream hardener. Using a clean spreader, fill to desired level. Do not exceed 1/4" depth. Allow to cure for at least 15 minutes before sanding. Abrade with 80-grit and follow up with 120-grit to achieve desired contour. Final finish with finer abrasives. If necessary, apply Eastwood’s 13521ZP Contour™ Glazing Putty for final finishing. Topcoat with quality primer, such as Eastwood’s Epoxy or Urethane Primers.
CAUTION: Do NOT return catalyzed material back into can. To avoid contamination, seal lid tightly after each use. Store in a cool dry place.
Always wear eye, skin and resp[oratory protection when using this product always apply in a well ventilated area. consult MSDS and product label for specific safety warnings
Made in Canada to Eastwood's strict specifications and quality standards
Surface must be clean and free of wax, grease and debris. Abrade surface using 36 grit, or finer. Thoroughly mix desired amount of material with 2% liquid hardener. Do not exceed 1/4" depth. Allow to cure 15 min before sanding. Abrade with 40-80 grit and follow up with 120 grit to desired contour 5. If necessary, apply Eastwoodâ€™s Polyester Glazing Putty (13521zp) for final finishing. Topcoat with quality primer such as Eastwoodâ€™s Epoxy or Urethane Primers. Do NOT return catalyzed material back into can.
Customers also viewed:
Sands all types of flat and contoured surfaces; use wet or dry
Premium body filler, plus 5 spreaders, 100 mixing board sheets
Stronger-than-it-looks portable stand holds up to 500 lbs.!