- Home
- Eastwood High-Build Self-Etching Primer Gray Aerosol
Details
High-Build Self-Etching Primer fills-in imperfections as it prepares bare metal for non-epoxy topcoats
Eastwood's High-Build Self-Etching Primer Aerosol has a true acid-etching formula that sticks to virtually any clean, bare, rust-free metal. Lacquer-based, metal-etching primer improves the adhesion and durability of most non-epoxy topcoats, and its high-build capability allows you to fill-in low spots and level-out surfaces prior to topcoating.
Eastwood's High-Build Self-Etching Primer Aerosol has a true acid-etching formula that sticks to virtually any clean, bare, rust-free metal. Lacquer-based, metal-etching primer improves the adhesion and durability of most non-epoxy topcoats, and its high-build capability allows you to fill-in low spots and level-out surfaces prior to topcoating.
- Etches and primes bare metal in 1 step
- Fills-in imperfections, sands easily
- Strengthens adhesion, durability, and color hold-out
- Use with non-epoxy primers and topcoats
- 16-oz. aerosol
HVLP Paint Gun - Eastwood EvolutionStarting at: $69.99 |
Eastwood PRE Painting PrepStarting at: $7.99 |
Dura-Block 7 Piece Sanding Blocks - DuraBlock
Only
$59.99
|
See this product in action!
About Eastwood High-Build Self-Etching Primer Gray Aerosol
Eastwood's High-Build Self-Etching Primer Aerosol improves the adhesion, durability, and color hold-out of topcoats. Not only does it etch and prime in one step, but its high-build formula also fills-in imperfections.
16-oz. aerosol
31160 Dura Block Sanding Blocks
10041Z PRE Painting Prep
12786ZP Urethane Primer, Quart
50242ZP Epoxy Primer, Quart
12776 Evolution Paint Gun
11456 Bandit Respirator
51136 Eastwood Paint Color Chart
10041Z PRE Painting Prep
12786ZP Urethane Primer, Quart
50242ZP Epoxy Primer, Quart
12776 Evolution Paint Gun
11456 Bandit Respirator
51136 Eastwood Paint Color Chart
Apply directly on clean bare metal that's free of waxes, grease and dirt. Use Eastwood's PRE Painting Prep to clean the surface. Apply several light coats until desired thickness and coverage is achieved. Wait 15 to 30 minutes between coats, with full cure in 48 hours, depending on conditions. For optimum results, apply at 70 degreesF at 50% humidity or less.
Always wear eye, skin and respiratory protection. Always apply in a well-ventilated area away from open flame. Consult MSDS for specific hazards and warnings.
Companion Products
Buy online or call 1-800-343-9353
 |
 |
 |
 |
 |
 |
 |
|