- Eastwood High-Build Self-Etching Primer Gray Quart
Eastwood High-Build Self-Etching Primer Gray Quart
Eastwood's High-Build Self-Etching Primer Quart has a true acid-etching formula that sticks to virtually any clean, bare, rust-free metal. Lacquer-based, metal-etching primer improves the adhesion and durability of most non-epoxy topcoats, and its high-build capability allows you to fill-in low spots and level-out surfaces prior to topcoating. You'll need a 1.8-2.0mm nozzle to spray this primer.
- Etches and primes bare metal in 1 step
- Fills-in imperfections, sands easily
- Strengthens adhesion, durability, and color hold-out
- Use with non-epoxy primers and topcoats
- 1-quart can
About Eastwood High-Build Self-Etching Primer Gray Quart
Eastwood's High Build Metal Etching primerâ€™s true acid etching formulation sticks to virtually any clean, bare, rust free metal. This lacquer based, self etching primer enhances the adhesion and durability of most non epoxy top coats. It's high build capabilities allow you to fill in low spots and level out surfaces prior to top coating.
32 Fl Ounces, one US Quart
31160 Dura Block Sanding Blocks; 10041Z PRE Painting Prep; 12786ZP Urethane Primer Quart; 50242ZP Epoxy Primer Quart; 12776 Evolution Paint Gun; 11456 Bandit Respirator; 51136 Eastwood Paint Color Chart
Apply directly on clean bare metal that's free of waxes, grease and dirt. Use Eastwood's PRE Painting Prep to clean the surface. Apply several light coats until desired thickness and coverage is achieved. Wait 15 to 30 minutes between coats, with full cure in 48 hours, depending on conditions. For optimum results, apply at 70 degreesF at 50% humidity or less.
Always wear eye, skin and respiratory protection. Always apply in a well ventilated area away from open flame. Consult MSDS for specific hazards and warnings.
Made in USA, 60 day warranty, 2 year shelf life
Ensure are to be applied is clean and free of waxes, grease and dirt. Use Eastwood's PRE Painting Prep to clean the surface. Apply directly to bare metal. Apply several light coats until desired thickness and coverage is achieved. wait 15 to 30 minutes between coats, full cure in 4 to 8 hours depending on conditions. For optimum results, apply at 70 dgerees F at 50% humidity or less.
Customers also viewed:
Lightweight, ergonomic, sprays beautifully...and saves you set-up time
Starting at: $79.99
Removes silicone, wax, polish, grease; promotes paint/powder adhesion
Starting at: $7.99
Sands all types of flat and contoured surfaces; use wet or dry