- Eastwood Rubberized Rust Encapsulator - Black Aerosol
Eastwood Rubberized Rust Encapsulator - Black Aerosol
Item #13651Z Brand: Eastwood
"Rubberized" Rust Encapsulator stays flexible as it stops rust in its tracks.
- Flexible finish protects surfaces from abrasions, and deadens sound
- Epoxy-fortified for better adhesion and durability
- Withstands up to 250°F
- One aerosol covers about 10 square feet
Eastwood's Rubberized Rust Encapsulator is the flexible version of our high-performance Rust Encapsulator coating that applies directly over rust or bare metal to provide long-term corrosion protection.
About Eastwood Rubberized Rust Encapsulator - Black Aerosol
Unlike off-the-shelf under coatings, the Rust Encapsulator rubber coating can be applied directly over rust and without the bubbling that creates air pockets thus trapping rust. Since its engineered with high-tech flex agents, its pliable finish protects surfaces from abrasions, road hazards and deadens sound. So durable it exceeded 1,000 hours of salt spray chamber testing, this surpasses the standards for a 2-component catalyzed coating! Simply apply directly over rust or bare metal; no need to topcoat. Remains flexible and durable. Satin black finish.
Aerosol net weight 15 ounces
10041z PRE Painting Prep 16060z Rust Encapsulator 51483z Rust Converter 12515z Internal Frame Coating 11175z Extreme Chassis Black 10025z Original Chassis Black 10025z Original Chassis Black 10020z Exhaust Paint
Use a wire brush to remove loose rust, scale and paint, and remove dust, grease and oil deposits. Feather surrounding paint with 220-grit sandpaper. Shake can for at least 2 minutes once the mixing ball starts to rattle. Hold the Rubberized Rust Encapsulator can 10"-12" above surface as you spray. A single coat dries to the touch in 20 minutes, and is thoroughly dry in 3-4 hours at 68°F. For greater durability, a second coat can be applied 1 hour after the first.
Always wear eye, skin and respiratory protection. Always apply in a well ventilated area away from open flame. VOC Content- ABP Max MIR 1.55
MADE IN THE USA
Ensure surface is clean and free of greases, oils and debris. Shake well. Ideal application conditions are 70Â°F at 50% or less humidity. Hold can 10-12" from surface, apply medium coat to ensure maximum adhesion. Will flash dry in 30-60 minutes, full cure in 24 hours. Apply coats in minimum one hour intervals. No topcoat is needed, because of its flexible properties a topcoat may not adhere. Do not apply to hot surfaces such as exhaust systems, engines or transmissions.
Customers also viewed:
Reformulated with TWICE the corrosion resistance
Starting at: $19.99
Apply a textured finish that stops—and hides—surface rustOnly $19.99
Stop rust in its tracks!
Starting at: $16.99
Stops rust, and protects the underside of your car!
Starting at: $22.99