- EW Silver Hi-Temp Paint Pint
EW Silver Hi-Temp Paint Pint
Item #10175Z Brand: Eastwood
About EW Silver Hi-Temp Paint Pint
The latest addition to our family of high performance exhaust manifold coatings provides a brilliant matte silver sheen - perfect for that custom look on muscle cars or street rods. Brush it on or thin to spray. It air dries to a tough, long-lasting finish which can be touched up if needed. Each can will cover four stock cast iron manifolds, or a pair of steel tube headers. Like our other high temp manifold coatings, it resists temperatures to 1,400 degrees F.
Sold in 1 pint containers.
Use the Manifold Smoothing Kit (46076) to smooth rough pitted surfaces before coating for a like new look. If you do not have access to an abrasive blaster to remove rust, wire brush the loose rust off.
Curing this or other manifold coatings in the oven is NOT recommended as the fumes are unpleasant, and warpage may occur. Coating has a bright cast aluminum look. This coating cannot be polished to a chrome-like shine. No thinning is normally needed for spray application. If thinning is desired use mineral spirits.
Contains Stoddard Solvent 8052-41-3, Aluminum Flake 7429-90-5, Mineral Spirits 64742-88-7, 1,2,4-Trimethyl Benzene 95-63-6, Phenylpropyl Silsesquioxand 68037-90-1, Xylene 1330-20-7. Keep from heat,sparks&open flame.Use w/adequate venting. Vapor harmful. For breathing difficulty, remove to fresh air & obtain medical attention. Harmful/fatal if swallowed. If swallowed,do not induce vomiting. Call physician immediately. Avoid prolonged contact with skin and breathing of vapor mist. Warning: This product contains a chemical known to State of California to cause birth defects & other reproductive harm.
Made in the USA. Approximate shelf life 6 months.
Remove corrosion by abrasive blasting or thorough wire brushing. Thoroughly spray down manifold/header with PRE Painting Prep (10041Z) to degrease. Allow surface to dry and apply 1 full hiding coat using a disposable foam type brush. Allow to dry overnight before installing on engine for cure. The dry manifold coating can be cured at any time without damage to the manifold or coating durability. This Silicone Resin based coating withstands up to 1,200 degrees F., one can covers 6 sq ft. Clean up with lacquer thinner. Use in a well ventilated area. Thin with Xylene or mineral spirits to sprayable consistancy.
Questions & Answers