• Home
  • External Coil Spring Compressor
External Coil Spring Compressor is rated 4.0 out of 5 by 3.
Rated 5 out of 5 by from These are good! They state that this is and external compressor but what makes it good is that it can be used internally. I did all the springs on my 65 Cutlass/442 with this tool.( I had an internal compressor but on the Cutlass springs the arms will not grip the coils. ) I put two of the compressors inside the spring on one side and in the correct position which put a slight bend in the spring which is necessary for installation and with two of them it made it safe in case on failed. Once the spring is in place I raised lower control arm a little and removed both compressors through the bottom hole in the arm in pieces. Very easy and safe.
Date published: 2015-01-13
Rated 5 out of 5 by from VERY SAFE I LOOKED AT A LOT OF COIL SPRING TOOLS.THIS ONE IS THE BEST,WELL MADE,EASY TO USE AND VERY SAFE,AFTER YOU ATTACH IT USING THE U BOLTS TO HOLD IT TO THE SPRING.
Date published: 2010-03-11
Rated 2 out of 5 by from A Disappointment I purchased this external coil compressor to use on the coil over shock application of my Triumph Spitfire. Unfortunately, it did not allow enough room to insert the shock in the coil and so was unsuitable for my application. Does appear to be well made. Will keep it in my tool stock.
Date published: 2015-10-06
  • 2016-05-03T07:36CST
  • bvseo_cps, prod_bvrr, vn_cps_3.2.0
  • cp_1, bvpage1
  • co_hasreviews, tv_0, tr_3
  • loc_en_US, sid_49016, PRD, sort_relevancy
  • clientName_eastwood

External Coil Spring Compressor

Item #49016 Brand: Horizon Tool

Works where an internal-type compressor won't; with 3 safety hooks

Details

For safe installation of coil springs, use this External Coil-Spring Compressor External Coil Spring Compressor works where an internal-type compressor won't. Unlike conventional internal compressors, the 3 shafts fit on the outside of the spring, so you can remove and install springs on virtually any vehicle.
  • Three 5/8"-dia. shafts
  • Three safety hooks retain tool on spring
  • NOT for MacPherson struts

More info...

About External Coil Spring Compressor

Makes installation and removal of front coil springs much easier. Uses your 15/16" socket. Includes 3 safety hooks and instructions. Made in the USA.

NOTE: Not for use on MacPherson struts.


Contents

Three 5/8"-diameter threaded shafts. The coil hooks accommodate coils up to 3/4" diameter. (Three safety hooks included are designed only to retain the tool on the spring and not secure the actual "finger".)


Safety

Use of safety glasses is highly recommended. NOTE: Not for use on MacPherson struts.


Customers also viewed: