• Home
  • Factory Gray High Temp Coating 1 Pt

Factory Gray High Temp Coating 1 Pt

Item #34105Z

Factory Gray High Temp Coating 1 Pt
This item ships from the manufacturer. Please allow 5-7 days for delivery.

Details

Duplicates the gray look of new cast iron. Air-dry silicone-based formula. Won't blister, crack or peel.

More info...

About Factory Gray High Temp Coating 1 Pt

Duplicates the gray look of new cast iron. Air-dry silicone-based formula. Won't blister, crack or peel.


Contents

1 Pint can of Factory Gray High Temp Coating 34105Z


FAQ’s

Curing in the oven is not recommended because unpleasant fumes are given off and it may cause the manifold to warp. If you must cure the manifolds in an oven, bolt flanges to something solid or to each other and place in a well ventilated oven for 20-30 minutes.


Safety

Contains Mineral Spirits 64742-88-7, Phenylpropyl Silsesquioxanes 68037-90-1, Toluene 108-88-3, Carbon Black 1333-86-4, Aluminum Flake 7429-90-5, Stoddard Solvent 8052-41-3.Keep from heat,sparks & open flame.Use w/adequate venting. Vapor harmful. Harmful/fatal if swallowed. If swallowed,do not induce vomiting. Call physician immediately. Avoid prolonged contact with skin and breathing of vapor mist. Warning: This product contains a chemical known to State of California to cause birth defects & other reproductive harm.


Warranty

Made in the USA. Shelf life approx. 6 months.


Application

Make sure surface to be coated is free of any coating or rust. Abrasive blast or wire brush to completely remove rust. Liberally Spray derusted manifold with PRE Painting Prep (10041Z) and allow to dry. Apply two medium coats (dabbing with a disposable foam brush works well to minimize brush marks), allow coating to dry overnight or longer before reinstalling part on car. Coating does not need to be heat cured, however it will further cure on start-up in 20-30 mins. Paint is thin enough to spray right from the can. Clean up with lacquer thinner Use a fresh cartridge in a properly fitted respirator if spraying.