Hotcoat Deluxe Powder Coat Kit

Home /
HotCoat Powder Coating /
Powder Coat Guns /
Hotcoat Deluxe Powder Coat Kit

Hotcoat Deluxe Powder Coat Kit

Item #10112

$139.99

Price as configured: $139.99

This innovative system will allow you to achieve the benefits of powder coating small parts instead of coating them with paint. All you need is a compressed air source (5-10 PSI from a portable tank with a regulator or a compressor), and an electric oven or toaster oven. The Hot Coat system should only be used in a clean, dry, well-ventilated work area! A dedicated electric oven should be used. Complete kit includes application gun, power unit (requires 115V AV 60HZ. grounded outlet),activator switch, disposable moisture filter, 8 oz. of high gloss black, and your choice of two 8 oz. standard colors. Detailed instructions will assist you with results.

3 Review(s) | Add Your Review

Qty: Select Powder Color #1 *
Qty: Select Powder Color #2 *

Add Items to Cart Qty:

This innovative system will allow you to achieve the benefits of powder coating small parts instead of coating them with paint. All you need is a compressed air source (5-10 PSI from a portable tank with a regulator or a compressor), and an electric oven or toaster oven. The Hot Coat system should only be used in a clean, dry, well-ventilated work area! A dedicated electric oven should be used. Complete kit includes application gun, power unit (requires 115V AV 60HZ. grounded outlet),activator switch, disposable moisture filter and 8 oz. of high gloss black. Detailed instruction will assist you with results.

The Deluxe HotCoat Powder Coating System includes the HotCoat gun with all interconnecting cables and power supply, 1 disposable moisture separator, a pack of 30 reusable silicone plugs, a 108' roll of high temperature masking tape, a 1 lb spool of.041 Stainless Steel Safety wire, a set of 3 bottles and lids, an 8 oz. can of Gloss Black powder, complete instructions and your choice of 2 additional 8 oz cans of standard colors.

The pack of 30 High Temp Silicone Plugs (10078) fit holes from 1/8" to 1", and are also used to support pieces in oven during curing. The High Temp Masking Tape (10027) prevents powder deposits on threads or other critical tolerance areas. It doesn't get gummy, like regular masking tape will when exposed to the curing process, and leaves a finer parting line. Use uncoated wire like our Stainless Steel.041" Safety Wire (43045) when hanging parts for coating and curing.

For improved flow out (less orange peel) bake coated parts at 500 degrees F until powder flows out (about 3-4 minutes for light sheet metal parts), then turn down the heat to 400 degrees F for a full 20 minutes. The High Performance Deflector (10128) greatly improves transfer efficiency. Use the Standard Deflector for applying powder porliferaly into recessed areas.

Use Disposable Dust Mask (22055) when handling or applying powder. Powder,like common flour, suspended in the air in high concentrations can be explosive. To minimize any explosion risk - sweep up, do not vacuum powder from the floor. Cure powder in a well ventilated area. The urethane powders we sell liberate a very minute amount of isocyanates when the powder flows out.This usually occurs about 3-5 minutes after the part is placed in the oven to bake. Wear a respirator, like our Professional Respirator (34029) with fresh cartridges when curing or inspecting flow out progress.