- Hotcoat Powder Corrosion Resistant Primer - 8oz
Hotcoat Powder Corrosion Resistant Primer - 8oz
Item #100 10301
finishes with this epoxy-based primer
Click here to see customer-submitted photos of our powder on their parts.
About Hotcoat Powder Corrosion Resistant Primer - 8oz
Priming with Powder - The legendary durability of powder-coated finishes is further enhanced with this epoxy based powder primer. If the utmost corrosion resistance and adhesion are important to you, you'll want to use this primer under every opaque powder we sell. (Not for use under our new line of High Temp Powders, or directly under translucent finishes.) For best results apply to clean bare metal and place in a preheated 400 degree F oven until flow out occures. DO NOT cure beyound flow out as adhesion will be adversely affected. Remove from oven, cool, apply powder of choice and bake as normal.
One 8 ounce bottle, enough to cover about 10 sq.ft.
Use PRE Painting Prep (10041z) to remove residual grease or oil before powder application.
Allowing the Epoxy powder primer to fully cure will cause poor adhesion of the top coat. Some degree of adhesion can be restored to fully cured epoxy primer by sanding with 220 grit paper, however adhesion is always best when the top coat is applied over the partially cured primer surface.
Customers also viewed:
Silicone tape creates fine parting lines; removes without residueOnly $59.99
Removes silicone, wax, polish, grease; promotes paint/powder adhesion