Hotcoat Powder Dk Grey/Battleship 10 lb

Be the first to review this product

$99.99
OR

Quick Overview

Extremely durable, chip-resistant
finish; coat and cure in under an hour

Hotcoat Powder Dk Grey/Battleship 10 lb

Double click on above image to view full picture

Zoom Out
Zoom In

More Views

  • Hotcoat Powder Dk Grey/Battleship 10 lb

Details

Industrial Powder Colors - These industrial powders are widely used by manufacturers of lawn and garden, sports equipment, and exterior furniture. These powders cure at 400 degrees F in 10 minutes after flow-out occures in a commercial oven or 20 minutes at 400 degrees F in a non-commercial oven. Made in the USA.

Additional Information

Air Pressure No
Air Volume No
Media Capacity No
Application For best durability powder must be applied to clean bare metal or over (<a href=" http://www.eastwood.com/hotcoat-powder-corrosion-resistant-primer-8oz.html">100 10301</a>) Corrosion Resistent Primer for increased durability. Abrasive blast and spray with PRE Painting Prep (<a href=" http://www.eastwood.com/ew-pre-painting-prep-aerosol-11oz.html">10041z</a>) or acetone. Treating the clean bare metal surface with Metal Wash (<a href=" http://www.eastwood.com/metal-wash-7-oz.html">10120</a>) or Oxisolv Rust Remover leaves a beneficial phosphate coating that improves adhesion and durability. Apply powder until full hiding of the surface is achieved. Heavier coatings may reduce durability but will improve smoothness. Cure for 10 min. at 400 degrees F in a commercial oven or 20 min. at 400 degrees F in a non-commercial oven after flow out.
Size/Content One 10lb.bag of powder, enough to cover about 200 square feet.
Accessories Use PRE Painting Prep (<a href=" http://www.eastwood.com/ew-pre-painting-prep-aerosol-11oz.html">10041z</a>) to remove residual grease or oil before powder application.
FAQ's No
Safety Info No

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.