• Home
  • Hotcoat Powder Gray Primer

Hotcoat Powder Gray Primer

Item #10301 Hotcoat Powder Gray Primer

Enhance durability of powder-coated finishes with this epoxy-based primer

In stock

  1. Powder Corrosion Resistant Primer 8 Oz
    Item #10301
    Only $9.39

    In stock

  2. Powder Corrosion Resistance Primer 1 Lb
    Item #10301LB
    Only $12.49

    In stock

  3. Powder Corrosion Resistance Primer 25 Lb
    Item #1030125LBS
    Only $219.99
  4. Powder Corrosion Resistance Primer 50 Lb
    Item #1030150LBS
    Only $399.99
$0.00

Details

Priming with Powder - The legendary durability of powder-coated finishes is further enhanced with this epoxy based powder primer. If the utmost corrosion resistance and adhesion are important to you, you'll want to use this primer under every opaque powder we sell. (Not for use under our translucent finishes.) For best results apply to clean bare metal and place in a preheated 400-degreeF oven until flow out occurs. DO NOT cure beyond flow out as adhesion will be adversely affected. Remove from oven, cool, apply powder of choice and bake as normal.

More info...

Contents

8 Ounce powders are packaged in plastic bottles
1 Pound powders are packaged in plastic Bags


Specifications

Color: Gray
Gloss Level: Flat 3±2
Cure Temperature: 400 Degrees
Cure Time: 20 Minutes after flowout
Powder Type: Epoxy
Finish: Smooth
Coverage: 1/2 lb. of powder is approximately 10-20 sq. ft.


FAQ

Allowing the Epoxy powder primer to fully cure will cause poor adhesion of the top coat. Some degree of adhesion can be restored to fully cured epoxy primer by sanding with 220 grit paper, however adhesion is always best when the top coat is applied over the partially cured primer surface.


Safety

When applying powder always apply it in a well ventilated area away from heat sparks and open flame. Always use a respirator rated for dust while applying powder. Always store powders in cool (less than 80 degrees Fahrenheit) dry (60 percent or less humidity) well ventilated area away from heat sparks and open flame.


Warranty

Eastwood 100% satisfaction guarantee


Application

CLEAN - Thoroughly strip and clean your metal part before coating. We recommend Eastwood Pre Painting Prep.

COAT - Apply using Eastwood DIY HotCoat Gun 11671A or the Eastwood Dual Voltage HotCoat Gun 11676.

CURE - Cure the part in an electric oven for recommended time. NEVER use an oven that is used for food.


Customer Reviews

Questions & Answers

Customers also viewed: