- Hotcoat Powder Gray Primer
Hotcoat Powder Gray Primer
Item #10301 Hotcoat Powder Gray Primer
8 Ounce powders are packaged in plastic bottles
1 Pound powders are packaged in plastic Bags
Gloss Level: Flat 3±2
Cure Temperature: 400 Degrees
Cure Time: 20 Minutes after flowout
Powder Type: Epoxy
Coverage: 1/2 lb. of powder is approximately 10-20 sq. ft.
Allowing the Epoxy powder primer to fully cure will cause poor adhesion of the top coat. Some degree of adhesion can be restored to fully cured epoxy primer by sanding with 220 grit paper, however adhesion is always best when the top coat is applied over the partially cured primer surface.
When applying powder always apply it in a well ventilated area away from heat sparks and open flame. Always use a respirator rated for dust while applying powder. Always store powders in cool (less than 80 degrees Fahrenheit) dry (60 percent or less humidity) well ventilated area away from heat sparks and open flame.
Eastwood 100% satisfaction guarantee
CLEAN - Thoroughly strip and clean your metal part before coating. We recommend Eastwood Pre Painting Prep.
COAT - Apply using Eastwood DIY HotCoat Gun 11671A or the Eastwood Dual Voltage HotCoat Gun 11676.
CURE - Cure the part in an electric oven for recommended time. NEVER use an oven that is used for food.
Questions & Answers
Customers also viewed:
Enhance durability of powder-coated finishes with this epoxy-based primer
Starting at: $8.99
Medium silver wrinkle color look of abrasive-blasted steel
Starting at: $18.99