• Home
  • Hotcoat Powder Reflective Chrome 8 oz

Hotcoat Powder Reflective Chrome 8 oz

Item #10285

Extremely durable, chip-resistant
finish; coat and cure in under an hour

Details

Reflective Chrome HotCoat Powder gives you an economical, long-lasting, near-chrome finish Extremely durable powder-coated surfaces are far more resistant to chipping, scratches, fading, and wear than other finishes.
  • Coat and cure in under an hour!
  • Separate clear topcoat required to prevent tarnish
  • Easy to apply
  • Quick color changes
  • Economical

About Hotcoat Powder Reflective Chrome 8 oz

Reflective Chrome is our most reflective powder. This polyester powder cures in 20 minutes (after flow-out) at 375 degreesF (depending on part; see "FAQs" tab). Reflective Chrome must be top-coated with our Gloss Clear (10093), Super Gloss Clear (10286) or one of our Translucent finishes to prevent tarnishing.

All HotCoat Powders are exclusively formulated for the Eastwood HotCoat System. They're optimized to promote static charge for uniform coverage and finish. All are UV- and fuel-resistant, so colors stay bright and vibrant longer.

8-oz. bottle of powder covers the same area as 2-3 cans of spray paint (about 10 sq. ft.), and clean-up is easy, since you simply sweep-up the oversprayed powder. Contains no environmentally harmful solvents.


MSDS Sheet

Click Here for Material Safety Data Sheet


Contents

One 8-oz. can of Reflective Chrome HotCoat Powder


Accessories

10093 HotCoat Powder Full Gloss Clear
10286 HotCoat Powder Super Gloss Clear
10198 Original HotCoat Powder-Coating System
11676 Dual-Voltage HotCoat Powder-Coating Gun


FAQs

(Q) How can I avoid substantial dulling of the Reflective Chrome once the clear powder topcoat is applied and cured?
(A) While some dulling is unavoidable, substantial dulling usually indicates that the Reflective Chrome was not completely cured. To fully cure this Reflective Chrome prior to applying and curing the clear powder, we recommend following these curing directions: Light sheet metal parts like valve covers, air cleaners, etc., will cure at 375 degreesF within 20-30 minutes after flow-out occurs (flow-out refers to the transition from a dull powder look to a glossy liquid look). Heavy parts like wheels and intake manifolds will cure at 375 degreesF within 50-60 minutes after flow-out occurs. Cure temperature must not exceed 375 degreesF since wrinkling may otherwise occur. This powder, and most others, will tolerate longer bake times without adversely effecting appearance or durability of the coating.


Customers also viewed: