- Infra Red Powder Curing Lamp 1800 Watts
Infra Red Powder Curing Lamp 1800 Watts
Item #10170 Brand: Infratech
Parts too big to cure in an oven? This Infrared Powder Curing Lamp can do the job in your shop or garage.
- Infrared lamp sets-up on optional stand in minutes
- Use in shop or garage
- For small parts to large housings
You're using our Eastwood Powdercoat System, but some of your parts require more space than inside a typical oven for curing. Or maybe you don't have a dedicated oven you can use strictly for powder-coating in your shop.
About Infra Red Powder Curing Lamp 1800 Watts
Our Infrared Powdercoat Cure Lamp will cure parts as small as bolts and brackets or as large as rear housings. Lamp can cure a 10" x 10" area at one time; simply move along the piece until complete.
Light housing measures 12.25" wide x 9.5" high x 6" deep. Lamp can be tilted 45 degrees up or down. 10" arm connects the light to the optional stand and can be locked in any position on the optional stand from 1' to 6' above the floor. Unit is rated at 1800 watts, and requires a 120vAC 15-amp circuit. Replacement lamp 10170B.
Instructions with Cure Charts
(Q) How often should the lamp be moved over the workpiece?
(A) Refer to the included instruction booklet's cure charts to determine how frequently the light should be moved.
(Q) What are some other tips?
(A) Long parts are best cured by hanging vertically, working from the bottom up. An entire part should be powder-coated before the curing process begins. If the part has seams it can be coated and cured in sections.
Do not focus the light on combustible materials. Do not operate the light unless it is securely attached to the supplied stand.
Questions & Answers
Customers also viewed:
Eastwood Bench Top Powder Coating OvenOnly $99.99
2 voltage settings allow complete coverage--tight spots to large areas
Measures from -22 to +500 degreesF without contactOnly $59.99