- Infrared Powder Curing System
Infrared Powder Curing System
Item #10180 Brand: Infratech
- Infrared lamp and stand set-up in minutes
- Use in shop or garage
- For small parts to large housings
- Head adjusts and tilts
For more information, contact Inside Sales at B2B@Eastwood.com or call 610-705-5416.
About Infrared Powder Curing System
Our Infrared Powdercoat Cure System will cure parts as small as bolts and brackets or as large as rear housings. Lamp reflector measures 10" x 8", and can cure a 10" x 10" area at one time; simply move along the piece until complete.
Light housing measures 12.25" wide x 9.5" high x 6" deep. Lamp can be tilted 45 degrees up or down. 10" arm connects the light to the stand and can be locked in any position on the stand from 1' to 6' above the floor. Unit is rated at 1800 watts, and requires a 120vAC 15-amp circuit.
6' Metal Stand
Instructions with Cure Charts
10170 Replacement Lamp Head
(Q) How often should the lamp be moved over the workpiece?
(A) Refer to the included instruction booklet's cure charts to determine how frequently the light should be moved.
(Q) What are some other tips?
(A) Long parts are best cured by hanging vertically, working from the bottom up. An entire part should be powder-coated before the curing process begins. If the part has seams it can be coated and cured in sections.
Do not focus the light on combustible materials. Do not operate the light unless it is securely attached to the supplied stand.