- Tunnel Ram Metallic Gray Basecoat Gallon Kit
Tunnel Ram Metallic Gray Basecoat Gallon Kit
- Apply a durable urethane finish wherever you live in the continental US, even CA
- Choose a fast, medium or slow Low-VOC Activator below
- Mixes 4:1 with your activator choice
- Makes 5 sprayable quarts
- Clearcoat required
About Tunnel Ram Metallic Gray Basecoat Gallon Kit
Eastwood's innovative Low VOC Urethane Basecoat Paint System combines the ease of use of conventional basecoats with the superior durability and unmatched performance of more modern urethanes. And because it's a Low VOC system, it meets regulatory limits in highly-regulated areas, eliminating the need to switch to a waterborne system. If you combine the basecoat system with our new line of Low VOC Primers and Clears, you'll be able to apply a durable urethane finish to any car, anywhere in the continental U.S. Mixes 4:1 with Eastwood's new Universal Low-VOC Urethane Activators (Fast, Medium, Slow).
One US Gallon of paint, 128 Fl. Oz One US Quart of activator, 32 Fl oz.
51550 Concours HVLP Paint Gun 10194ZP PRE Painting Prep 20474 4-stage air drying system 50307ZP Low VOC Clear 50300ZP Low VOC Urethane Primer 11455/11456 respirator 51559 Digital regulator 51561Z Norton Liquid Ice Buff System
Use Eastwood's PRE Painting Prep to prep surface and remove all traces of contaminants. Sand existing finish with 400-600-grit abrasive. Clean surface again. Mix 4:1 with appropriate-speed activator. Reduction not necessary. Shake well. Use HVLP 1.2mm-1.4mm gun nozzle size. Apply in 2 medium wet coats with 50% overlap. Allow 10 minutes flash time between each coat. Clear coat can be applied after 20-30 minutes. Maximum recoat time is 18 hours; otherwise surface must abraded with 400-600-grit.
Always wear eye, skin and respiratory protection. Always paint in a well ventilated area. Consult MSDS and Tech Data sheets for proper safety precautions and usage. VOC= 3.5 lbs.gallon
Product Information Sheet
Prep surface and remove all traces of contaminants. Use Eastwood's PRE Prep. Sand existing finish with 400-600 grit abrasive. Re-clean surface. Mix 4:1 with appropriate speed activator. Reduction not necessary. Shake Well. HVLP Gun Nozzle Size 1.2mm-1.4mm. Apply in 2 medium wet coats with 50% over lap. Allow 10 minutes flash time between each coat. Clear coat can be applied after 20-30 minutes. Maximum re-coat time is 18 hours. Otherwise surface must be abraded with 400-600 grit. Use 50307ZP Low VOC Clear & Activator. Pot life is about 2 hours at 70'F
Customers also viewed:
Removes silicone, wax, polish, grease; promotes paint/powder adhesion
Starting at: $8.99
Spray-on a "show-car" finish; powered by your home compressor
Holds up to 3 gravity-feed spray guns at one time for filling