• Home
  • Rat Rod Satin Black Paint - 3 Qts. without Activator

    Rat Rod Satin Black Paint - 3 Qts. without Activator

    Item #21855ZP

    Give your "rat rod" that perfect
    satin-black finish; no activator

    Details

    Give your "rat rod" that perfect, smooth, satin-black finish Some project rods just won't look finished until you've put on that distinctive, satin black finish. Our Rat Rod Satin Black is the only way to go!
    • Single-step acrylic urethane
    • Exceptional long-term durability
    • UV- and chemical-resistant
    • Resists scratching and marring from normal wear

    More info...

    About Rat Rod Satin Black Paint - 3 Qts. without Activator

    This 3/4 gallon of Rat Rod Black is mixed 3:1 with the (21856ZP) Activator. Both items are available as a kit (21857ZP). No further reduction required. Goes on smooth provides complete coverage in two medium wet coats.


    Contents

    3-quart Rat Rod Satin Black


    Accessories

    21856ZP 1-quart Activator
    21857ZP 3-quart Rat Rod Satin Black PLUS 1-qt. Activator


    Application

    Clean surfaces of all contaminants. Abrade surface to be painted with a minimum of 320-grit sandpaper working up to a 600-grit for maximum adhesion. Re-clean surface. After shaking paint, mix 3 parts paint with 1 part activator (sold separately or as part of a kit). Use caution mixing materials as paint may begin to gel after 2 hours at 70 degreesF. Set your HVLP gun at 8-10 psi. Use 1.4mm-1.8mm tip. This color is designed to give complete coverage in 2 coats. Allow 10 minutes flash time between coats. Should be tack-free in 45-60 minutes; full cure in 18 hours.


    MSDS Sheet

    Click Here for Material Safety Data Sheet


    Application

    Clean surfaces of all contaminants. Abrade surface to be painted with a minimum of 320 grit sandpaper working up to a 600 grit for maximum adhesion. Re-clean surface. After shaking paint, mix 3 parts paint with 1 part activator. Use caution mixing materials as paint may begin to gel after 2 hours at 70Ö. HVLP gun setting 8-10psi 1.4-1.8mm tip. This color is designed to give complete coverage in 2 coats. Allow 10 minutes flash time between coats, should be tack free in 45-60 minutes, full cure in 18 hours.


    Customers also viewed: