Details

About Hotcoat Starter KIt

Besides the 11,000-watt HotCoat® gun itself, you'll also get 8-oz. bottles of 4 popular colors, an extra bottle with lid, high-temp. fiberglass masking tape to protect bolt threads and studs from powder, high-temp. silicone plug assortment to plug holes, plus a disposable in-line air filter to make sure only clean dry air gets to your gun.

Why powder coat? Because it gives you one of the most economical, color-durable, and longest-lasting finishes available. You'll find powder-coated surfaces are far more resistant to chipping, scratches, fading, and wear than other finishes, and the color selection is virtually unlimited, with high and low gloss, metallic, and clear finishes available. And thanks to the UV resistance of many of the powders, colors stay bright and vibrant longer. Texture selections range from smooth surfaces to a wrinkled or matte finish, plus rough textures designed for hiding surface imperfections.

One 8-oz. bottle of powder (4 are included) covers the same area as 2-3 cans of spray paint, and clean-up is easy, since you can simply sweep-up the oversprayed powder. Contains no environmentally harmful solvents. HotCoat powder coating requires a 5-10 psi compressed air source and dedicated electric oven (or toaster oven). Imported.

Original HotCoat® Gun with power source, instructions
1 Extra Plastic 8-oz. Bottle with screw-on lid
10027 High-Temp. Fiberglass Masking Tape, 1/2" wide, 36 yards long
10078 High-Temp. Silicone Plugs Assortment, 30 pcs.
43045 Stainless Steel Safety Wire, 1-lb. spool
34066 Disposable In-Line Air Filter
100-10107 HotCoat® Powder, High-Gloss Black, 8-oz. bottle
100-10152 HotCoat® Powder, Machine Gray, 8-oz. bottle
100-10103 HotCoat® Powder, Satin Black, 8-oz. bottle
100-10105 HotCoat® Powder, Bright Red, 8-oz. bottle

1-year warranty on HotCoat® Application Gun

Power unit supplies over 9000v DC at 15 micro amps. Plugs into grounded 110-120v AC outlet. Gun requires as little as 0.5 cfm at 5-10 psi. The 50061 Eastwood Air Brush Compressor works well. Fill cup no more than 1/4 to 1/3 full, and wave the nozzle in a circular motion about 4-6" from the surface best results. Do not apply powder into a small boxed area.

51558 HotCoat Powder Coating Chip Chart
19415ZP Fast Etch (Qt.)
12850 Powder Coat & Paint Dissolver (Gal.)
11476 Compact Infrared Non-Contact Thermometer
10288Z Hi-Temp Lab Metal Repair Compound
12582ZP Anodize Remover (Qt.)
10170 Infrared Powder Curing Lamp
10421 High-Temp Masking Tape Kit

Use a disposable dust mask when handling or applying powder. Powder, like common flour, can be explosive when suspended in the air in high concentrations. To minimize any explosion risk, sweep up—do not vacuum—powder from the floor. Cure powder in a well-ventilated area. The urethane powders we sell liberate a very minute amount of isocyanates when the powder flows out. This usually occurs about 3-5 minutes after the part is placed in the oven to bake. Wear a respirator with fresh filter cartridges when curing or inspecting flow-out progress.