Eastwood Gold Digger Metallic SSU Paint 3:1 96 oz
Item #13729ZP Brand: Eastwood
About Eastwood Gold Digger Metallic SSU Paint 3:1 96 oz
Eastwood Gold Digger Metallic is a premium single-stage urethane topcoat that provides exceptional long-lasting beauty and durability. This premium two component system is blended with top-quality raw materials and advanced composition coatings technology. Superior to acrylic, alkyd and lacquer coatings, a catalyzed urethane system offers unsurpassed durability and resistance to UV exposure, chemicals and annoying stone chips. Eastwood's line of paints will hold their gloss longer and won't yellow. 96 Fl. Oz 3:1 Single stage Topcoat system, requires 21856ZP activator to make one gallon.
96 fluid ounces
21856 ZP activator required. 10194 ZP PRE Quart 50250zp European Clear Gallon 12817 paint gun accessory kit 12846Z Aerosol Injected Cleaner 12454Z Block sanding kit, 12252 3-gun set 20472 Air management system 12776 Evolution Paint Gun
Always wear appropriate eye, skin and respiratory protection. Consult MSDS for specific precautions and warnings.
Made in USA 60 defect warranty
Clean surfaces of all contaminants. Abrade surface to be painted with a minimum of 320 grit sandpaper working up to a 600 grit for maximum adhesions. Re-clean surface. After shaking paint, mix 3 parts paint with 1 part activator Use caution mixing materials as paint may begin to gel after 2 hours at 70Â°. HVLP gun setting 8-10psi 1.2-1.6mm tip. Eastwood paint is designed to give complete coverage in 2 coats. Allow 10 minutes flash time between coats, should be tack free in 45-60 minutes, full cure in 18 hours. Product Information sheets available at eastwood.com
Loved this stuff
(Posted on 6/29/12)
Review by Wink
Price Value Quality
It is a Med-Heavy Metallic, so you have to stir appropriately.
Actually used my old cheap Harbor freight airbrush to spray the stripes, since the quality of the brush is so poor it will actually spray heavy metallics ok.! :)
Use good fine line tape to cut down on edge grouping of the metallic.
Finish sands very well. Hope to use the rest of it on the next project.
Pic is after sanding with 1500, but before buffing.