TLC Colorgard Black 4 oz

    Item #25270Z Brand: Techline

    Quality
    Price
    Value
    4 Review(s)

    Details

    Make your steel tube headers and cast manifolds stand out with a rich black coating and protect them to 1300F while lowering underhood temperatures up to 20 degrees. Apply to gently blasted surface with a touch up gun or airbrush, let dry, then run engine to fully cure with exhaust heat. Do not bake this coating in an oven. Includes 4oz. of Satin Black Coating.

    About TLC Colorgard Black 4 oz

    Make your steel tube headers and cast manifolds stand out with a rich black coating and protect them to 1300F while lowering underhood temperatures up to 20 degrees. Apply to gently blasted surface with a touch up gun or airbrush, let dry, then run engine to fully cure with exhaust heat. Do not bake this coating in an oven. Includes 4oz. of Satin Black Coating.


    MSDS SHeet

    Click Here for Material Safety Data Sheet


    Customers also viewed:

    Customer Reviews

    4 Item(s)

    per page
    Great product. (Posted on 8/18/13)
    Review by Anthony
    Quality
    Price
    Value
    3rd Method of curing. Sandblasted headers and used HVLP Eastwood touch up gun. Applied to 2 coats of paint. Hung headers and used a propane torch to heat each runner for 1 hour. Used a section of sheet metal with smaller hole to restrict convection flow of heat from propane torch at outlet. Headers have been on Rotary engine for 300 miles and still look as if they have just been painted. Important note, paint directly after sand blasting. Cure after paint dries. The rotary exhaust if very hot, I used the titanium paint as it had the highest heat rating.
    Not as advertized. (Posted on 9/26/12)
    Review by Matt
    Price
    Value
    Quality
    Product was applied in 4 coats with a professional-grade automotive paint gun to a freshly cleaned and sand blasted exhaust manifold. It was allowed to dry for 36 hours before installation. The product was then "cured" onto the manifold by doing the recommended running cycle on the bottle. 70% of the product flaked-off the manifold within 20 miles of light driving.

    If you are considering purchasing this product, just pay a powdercoater to do a proper ceramic coating on your header so you just have to remove and install your part once.

    I highly advise against purchasing this product unless you have a car that is never intended to be driven.
    Quality, Easy to use Product (Posted on 1/27/10)
    Review by Motorheads Performance
    Price
    Value
    Quality
    When I first received the (very) small can of thin looking paint, I was skeptical of just how well it would do the job. My daughter was performing her first restoration project on her '85 CJ Jeep, and I thought it would be too much to attempt painting headers. But, after following the instructions and spraying the headers, we were very impressed. The product sprayed flawlessly, evenly, and produced a better-than-factory finish that is impressive. We will definitely use this product again!
    Nice coating (Posted on 1/26/10)
    Review by oguitar
    Price
    Value
    Quality
    I coated my turbo and exhaust manifold with this coating. The quality looks great. The rusty old manifolds look nice and shiny. I was not able to get the coating to adhere properly to the polished surfaces after my P&P work.

    I did not use an air gun although I did have one. I found the coating easier to apply with a paintbrush. Haven't had the chance to install these parts on my WRX yet but I am sure the coating will do fine.

    4 Item(s)

    per page

    Write Your Own Review

    Only registered users can write reviews. Please, log in or register