Eastwood Rat Rod Satin Black Paint

    Item #21857ZP Rat Rod Satin Black Paint

    Price
    Value
    Quality
    21 Review(s)

    Details

    Eastwood's premium Rat Rod Satin Black Single-Stage Acrylic Urethane Topcoat provides exceptional long-lasting beauty and durability.

    Some project rods just won't look finished until you've put on that distinctive, satin car paint finish. Our Rat Rod paint is the only way to go! This premium 2-component topcoat system is blended with top-quality raw materials and advanced composition coatings technology. Superior to acrylic, alkyd and lacquer coatings. Eastwood's single-stage urethane paints hold their gloss longer and won't yellow.

    • 96-fl.-oz. Rat Rod Flat Black Automotive Paint
    • 32-fl.-oz. Activator required (included in 21857)
    • Catalyzed urethane for unsurpassed durability
    • Highly resistant to UV rays, chemicals, chips

    About Eastwood Rat Rod Satin Black Paint

    Sure, some like to "drive her in primer", or opt for a quick "rattle-can" paint job, but this activated, single-step acrylic urethane Rat Rod car paint is a smarter and much longer-lasting choice! Mix 3:1 with activator; no further reduction required.

    Due to regulations pertaining to recycling, we are unable to ship this product to Alberta, Canada.


    Contents

    Choose from the following:
    21857ZP is the Rat Rod Flat Black Single-Stage Urethane Topcoat, Gallon, with Activator; enough to coat the outside of most cars
    21855ZP is the Rat Rod Flat Black Topcoat, Gallon, without Activator
    51379ZP is the Rat Rod Flat Black Topcoat, 1-qt. can, with 8-oz. Activator
    21856ZP is the Eastwood Urethane Activator, 32-oz.


    Application

    Clean surfaces of all contaminants. Abrade surface to be painted with a minimum of 320-grit sandpaper, working up to a 600-grit for maximum adhesion. Re-clean surface. After shaking paint, mix 3 parts paint with 1 part activator. Use caution mixing materials as paint may begin to gel after 2 hours at 70°F. HVLP gun setting: 8-10 PSI, with a 1.4mm-1.8mm tip. This color is formulated to give complete coverage in 2-3 coats. Allow 10 minutes flash time between coats; should be tack-free in 45-60 minutes, with full cure in 18 hours.


    Accessories

    10194ZP PRE Painting Prep, Quart
    51605 Concours HVLP Paint Gun Kit
    51686 Concours HVLP Detail Gun
    20474 4-Stage Dry Air System
    50040ZP Master Paint Prep Kit
    51561Z 6" Liquid Ice Buffing Kit
    34053 Hobby Air Fresh-Air System
    51559 Digital Regulator
    50244ZP Epoxy Gray Primer, Gallon
    50245ZP Epoxy Primer Catalyst, Gallon
    50240ZP 2K Urethane Gray Primer, Gallon
    50241ZP 2K Urethane Primer Catalyst, Quart


    FAQs

    (Q) How much paint do I need?
    (A) Typically one gallon per car. If you are also painting jambs, under the hood, or the trunk, use 2 gallons. For large cars and pickup trucks, use 2 gallons. Number of coats, prep and application methods will affect the amount of paint required.


    Product Information Sheet

    Click here to view product information sheet


    Safety

    Always wear proper eye, skin and respiratory protection. Always paint in a well-ventilated area away from sparks and open flame. Consult MSDS and product data sheets for proper safety precautions.


    Customers also viewed:

    Customer Reviews

    Items 1 to 10 of 21 total

    per page
    1. 1
    2. 2
    3. 3
    High Quality (Posted on 5/30/14)
    Review by Larry
    Price
    Value
    Quality
    It needs to be at least suggested that you will need a reducer. The description of the product indicates the Urethane and Activator are all that will be needed. My first attempt was with the Urethane and Activator alone only to have to order the Reducer later. The label on the Paint and Reducer suggest using the Product Information Sheet for paint gun settings and more specific mixing and application instructions of which a copy was not sent. Just suggesting. Thanks
    paint seemed old (Posted on 9/9/13)
    Review by Carma
    Price
    Value
    Quality
    after three tries at trying to get a good paint job I gave up on this paint. the price sounded to good to be true and it was.Could not get the paint to stop streaking no matter how much I stirred the paint before painting.
    Great deal! (Posted on 5/9/13)
    Review by SHAWN
    Price
    Value
    Quality
    Can't find a 2k urethane satin black of this quality anywhere else. Thanks Eastwood!
    Rat Rod Satin kit, Good stuff. (Posted on 4/11/13)
    Review by Charlie
    Price
    Value
    Quality
    Gave it 5 stars on price and value because chances you will find satin urethane and hardener in a kit for this low of a price is slim to none. Value, it performs as good as the best in the price range

    Quality I would say is good for the price. Needs to be thinned quite a bit, regular old urethane reducer worked for me. I had some laying around. With just the activator/hardener and paint its extremely thick @ at 68º ambient temp.

    When mixed up 4:1:1 with reducer it sprayed well out of a 1.4 tip but could have used a bit more flow. Don't know if it was the paints fault or maybe it could have been reduced slightly more.

    Coverage was great, super black, covered extremely well in just two coats. I finished with three coats.

    As most single stage paints this self leveled quite well, leaving a super smooth finish with almost no orange peal once dry.

    Took a few hours to go from high gloss to reach full satin.

    Overall I give this product an A-

    Would like alittle better flow.
    Advertise/suggest using a reducer

    Great product! Price is unbeatable.
    Rat Rod satin black (Posted on 12/9/12)
    Review by Fran
    Quality
    Price
    Value
    Its a very good product for the money. flows good, and lays even better. leaves a nice low sheen finish. highly recommend this paint.
    Very dam good paint (Posted on 11/11/12)
    Review by Christopher
    Quality
    Price
    Value
    I painted my harley for the first time myself, never painted berore took two weekends for prep and two get ready,shot and the paint went on perfect used two coats of flat clear really turn out nice. a lot of u tube classes
    Good (Posted on 11/11/12)
    Review by Big E
    Quality
    Price
    Value
    my first time painting went on real good with two coats of flat clear
    Nice Product (Posted on 1/11/12)
    Review by CS
    Quality
    Price
    Value
    Used it on a CJ7. Flows out nice and covers well. Leaves a nice matte black finish. Hope its durability is as good as its looks.
    great product (Posted on 1/7/12)
    Review by ron
    Quality
    Price
    Value
    3rd time painting a car and it turned out great. the paint was very easy to mix and spray. its a GREAT color and it has a great name as wll
    Awesome Combo (Posted on 10/19/11)
    Review by Weide27
    Value
    Quality
    Price
    I used this paint on my 1998 Dodge Durango. Ive looked all over for a nice easy application for a matte black finish. The paint went on easy and quick. I was surprised with how simple it went on, and the results are amazing. I get looks every time i drive it. This paint really set off the feel i was trying to get for the truck. It gives it that tough off road look that i was looking for. It really sets off the lift and bigger mud tires i put on it. It went over the bondo and primer awesome. I couldnt have asked for a better product for the price. I will use this product again on my new project a 1976 Vette.

    Items 1 to 10 of 21 total

    per page
    1. 1
    2. 2
    3. 3

    Write Your Own Review

    Only registered users can write reviews. Please, log in or register