• Home
  • Eastwood Rubberized Rust Encapsulator Quart

Eastwood Rubberized Rust Encapsulator Quart

Item #11864ZP

Stays flexible as it stops rust in its tracks

Details

"Rubberized" Rust Encapsulator stays flexible as it stops rust in its tracks...outperforms standard undercoatings Eastwood's Rubberized Rust Encapsulator is the flexible version of our high-performance Rust Encapsulator coating that applies directly over rust or bare metal to provide long-term corrosion protection.
  • Engineered with high-tech flex agents; less "rubber"
  • Epoxy-fortified for better adhesion and durability
  • Exceeded 1,000 hours of testing in a salt spray chamber
  • Withstands up to 250°F

Note: this item cannot ship to CA, but the aerosol version (13615Z) can ship to CA.

About Eastwood Rubberized Rust Encapsulator Quart

Unlike off the shelf under coatings, Rubberized Rust Encapsulator can be applied directly over rust and without the bubbling that creates air pockets thus trapping rust. Since its engineered with high tech flex agents, its pliable finish protects surfaces from abrasions, road hazards and deadens sound. So durable it exceeded 1,000 hours of salt spray chamber testing, this surpasses the standards for a 2 component catalyzed coating! Simply apply with an undercoating gun, such as 20441, directly over rust or bare metal, no need to topcoat. Remains flexible and durable. Satin black finish.


Contents

32 Fluid Ounces


Accessories

20441 Undercoating Gun. 10041Z PRE Painting Prep. 13651 Z Rubberized Rust Encapsulator aerosol. 19867 Professional Undercoating Gun. 16017 ZP Heavy Duty Anti Rust Quart. 12515 Z Internal Frame Coating.12742 Z Flexible Sealer and Sound Deadener.


Application

Use a wire brush to remove loose rust, scale and paint, and remove dust, grease and oil deposits. Feather surrounding paint with 220-grit sandpaper. Apply with an undercoating gun (like our 20441 Undercoating Gun Kit); no need to topcoat, unless desired. Use over or under body fillers.


Safety

Always wear eye, skin and respiratory protection. Always apply in a well ventilated area away from open flame.


Warranty

Made in USA


Application

Apply with a brush or with an undercoating gun. Remove loose scale and rust. Apply directly over surface rust and bare metal to desired film build. Allow 24 hours for full cure for 68 degree F at 50 percent humidity. Thickness and weather conditions can affect dry times.


Customers also viewed: