- Eastwood Rust Encapsulator Aerosol Red 15 oz
Eastwood Rust Encapsulator Aerosol Red 15 oz
Item #16040Z Brand: Eastwood
Stop rust in its tracks! Our "Red" Rust Encapsulator has been reformulated with TWICE the corrosion resistance!
- Twice the corrosion resistance of our original formula for greater durability
- Epoxy-fortified for better adhesion and topcoat compatibility
- Penetrates deeper to prevent rust from spreading or forming, even in hard-to-reach areas
- Cures faster
- 15-oz. aerosol covers about 10 sq. ft.
- As seen on "My Classic Car" TV show
You thought it was good before...wait ’til you try this Red Rust Encapsulator! It seals and stops rust and corrosion from spreading, but it performs even better than our original formula. Tested against well-known brands, the Eastwood Rust Encapsulator has proven to be superior in sunlight resistance, preventing rust creep, and overall durability.
About Eastwood Rust Encapsulator Aerosol Red 15 oz
Eastwood Rust Encapsulator has been tested by an independent lab to be one of the most effective rust-preventive products yet (tested to 500 hours in a salt-spray chamber). Red Rust Encapsulator is a great primer for floor pans and other underbody parts. It fills tiny pin-holes and surface irregularities, and is compatible with lacquer, enamel and urethane topcoats (including Eastwood Chassis Black). For the absolute ultimate rust remedy, first brush or spray-on Eastwood Rust Converter, then prime with Rust Encapsulator. One 15-oz. aerosol covers about 10 sq. ft., and contains no isocyanates. Heat-resistant up to 400 degreesF. Made in the USA.
Buy 3 or more and SAVE over individual pricing!
Use a wire brush to remove loose rust, scale and paint, and remove dust, grease and oil deposits. Feather surrounding paint with 220-grit sandpaper. Shake can for at least 2 minutes once the mixing ball starts to rattle. Hold the Rust Encapsulator can 10-12" above surface as you spray. A single coat dries to the touch in 20 minutes, and is thoroughly dry in 3-4 hours at 68 degreesF. For greater durability, a second coat can be applied 1 hour after the first. Allow 6-8 hours after the last coat before applying topcoat. Use over or under body fillers.
In places where little or no surface prep can be done, our 16017ZP Heavy-Duty Anti-Rust (Qt.) is actually a better choice for applying into blind areas such as box sections. Buy 3 or more quart cans and save!
(Q) Can Red Rust Encapsulator be applied with the Undercoating System?
(A) Technically, yes, but this application isn't recommended because Rust Encapsulator requires surface to be free of grease, oil, and loose rust. The best product to coat inside box sections is the 16017ZP Heavy-Duty Anti-Rust (Qt.). This waxy, oily product flows into pinch welds and through rust to seal surfaces from contact with moisture and air, but cannot be painted over, so it's only suitable for inside box sections that don't show. Use lacquer thinner for cleanup.
Work in a well-ventilated area when applying this product. The use of a respirator is recommended. Shake vigorously for 2 minutes before spraying.
Customers also viewed:
Stop rust in its tracks!
Starting at: $16.99
Destroys rust hiding inside chassis, so it won't rust thru
Starting at: $17.99
Stops rust, and protects the underside of your car!
Starting at: $18.99