• Home
  • Stud Welder Dent-Pulling System Magnaclamp

    Stud Welder Dent-Pulling System Magnaclamp

    Item #31041 F

    Allows you to pull four or five pins at one time
    This item ships directly from the manufacturer. Please allow one to two weeks for delivery.

    Details

    This Magna clamp allows you to pull four or five pins at one time. Conventional dent pullers require that you drill a series of holes in the sheet metal, which can weaken the panel. The stub welder system spot welds pins to the surface of the metal. Then use the included slide puller to pull the dent out. After the dent has been repaired, simply snip off the pins and then grind off the remainder of the pin. The results are a great-looking repair with minimal filler use.

    More info...

    About Stud Welder Dent-Pulling System Magnaclamp

    This Magma clamp allows you to pull four or five pins at one time. Conventional dent pullers require that you drill a series of holes in the sheet metal, which can weaken the panel. The stub welder system spot welds pins to the surface of the metal. Then use the included slide puller to pull the dent out. After the dent has been repaired, simply snip off the pins and then grind off the remainder of the pin. The results are a great looking repair with minimal filler use. This item ships directly from the vendor. Please allow one to two weeks for delivery.


    Contents

    Magna clamp pin pulling tool


    Accessories

    The Shrinking Electrode Tip (31041) turns your stud Welder into an effective tool for shrinking metal. Simply install the shrinking electrode, push the tip fully against the raised spot and trigger the gun for 1/2 second 2-3 times. If dent does not shrink tap lightly with a body hammer.


    Safety

    NOTE: Stray sparks normally occur during use of the stud welders. Keep all flammables out of the immediate area!