- Stud Welder Dent Pulling System
Stud Welder Dent Pulling System
Item #31041 Brand: Motor Guard Corp
Stud Welder Dent-Pulling System makes a hole-free dent repair, so it won’t weaken the panel, and needs less filler.
- Stud welder spot-welds pins onto the dented metal surface
- Pull the pins to pull-out the dent
- Snip the pins, then grind the rest down
3-step repair works without drilling holes, so it won't compromise the strength of the panel. The result is a professional-looking dent repair that requires minimal filler.
About Stud Welder Dent Pulling System
Conventional dent pullers require that you drill a series of holes in the sheet metal to make your dent repair, but that can weaken the panel. Instead, this Stud Welder System spot-welds a series of pins onto the surface of the dented metal. Then use the slide puller (included) to pull the pins that pull the dent out. Once the dent has been repaired, simply snip off the pins, then grind off the remainder. The result is a professional-looking dent repair that requires minimal filler. 5-year manufacturer's warranty.
Stud Welder Kit includes the 110v self-contained stud gun, large slide hammer puller with 2-lb. sliding weight, pack of 100 draw pins (2mm), and an instruction manual.
(Q) Do I need a 220-volt system to operate this?
(A) No, standard 110v will work.
(Q) Do I need a welding mask when using this?
(A) It’s not necessary, but don’t look directly into the momentary flash.
(Q) How do I get the pins off after they’ve been welded onto the surface?
(A) After you’ve made your pulls, simply snip or grind the pins off.
Stray sparks normally occur during use of this tool. Therefore, keep all flammables out of the immediate area.
Questions & Answers
Customers also viewed:
Pulls-out minor dings, dents precisely; works with 2.0 to 2.6mm pinsOnly $37.79