• Home
  • Follex Molding Masking Tape

    Follex Molding Masking Tape

    Item #15318

    At last a masking tape designed for the problems of masking automotive moldings and glass

    Details

    At last a masking tape designed for the problems of masking automotive moldings and glass

    This automotive masking tape was created specifically to keep paint off of trim, moldings and glass. Also great for masking around taillights and headlights too. The ½ inch wide clear plastic edge will slides under molding or trim, to insure that the paint goes where it needs to go, without creating any hard lines or overspray. You can mask molding completely, while making sure the paint flows all the way to the very edge of it, or even under it slightly. Finally a way to paint a car without all the difficult removal and replacing of moldings, without it looking like corners were cut. Plus the roll is perforated every 2 inches for easy tearing.

    • Masks around molding, lights & glass
    • Saves time
    • 1/2 inch plastic edge with 1 ¾ inch paper tape
    • Perforated every 2 inches for tearing
    • 33 feet per roll

    More info...

    About Follex Molding Masking Tape

    This specially designed paint masking tape has a flexible, clear plastic edge used for masking around windshields, molding, sunroofs and tail lights. This eliminates the need to remove or mask around the molding. The plastic edge slides under the molding ensuring no paint will go in or on the molding. The tape is 1.75 inches wide x 33 inches long, with a clear plastic edge measuring 1/2 inch and is perforated every 2 inches for easy tearing.


    Contents

    Contains one roll 1.75 inch x 33 inch


    Accessories

    12776 Evolution HVLP Paint Gun 11456 Respirator, 14743 masking paper, 11844 Canvas wheel maskers, 14161 Nylon Pry Bar Set. 51515 Norton Masking Tape


    Safety

    Always wear eye, skin and respiratory protection when painting. Apply in a well ventilated area away from open flame.


    Application

    Tuck the hard plastic edge under the molding. A plastic pry may be necessary. Fold edge over and attach masking paper or tape.


    Customers also viewed: