• Home
  • VHT High Temp Primer 11 oz Flat Gray

VHT High Temp Primer 11 oz Flat Gray

Item #13618Z Brand: VHT

Flameproof™ Primer for
VHT's Flameproof™ Coatings

Details

VHT's Flameproof coatings will renew and extend the life of any surface exposed to high temperatures. This coating is a matte/flat finish, with a silicone base. Coating withstand temperatures up to 2000°F Ideal for exhaust systems, headers and engine components. Flameproof coatings cure on the vehicle while in service. See applications tab for curing instructions. 11oz Aerosol

More info...

About VHT High Temp Primer 11 oz Flat Gray

VHT's Flameproof coatings will renew and extend the life of any surface exposed to high temperatures. This coating is a matte/flat finish, with a silicone base. Coating withstand temperatures up to 2000°F Ideal for exhaust systems, headers and engine components. Flameproof coatings cure on the vehicle while in service. See applications tab for curing instructions. 11oz Aerosol


Contents

11 oz aerosol


Accessories

10041z or 11949z PRE Painting Pep 12196z Chassis Kleen 11756z Brake Gray 11175z or 11172z Extreme Chassis Black 10024z Underhood Black 12461 Pig Mats 12032z Underhood Black Matte Finish 10032z Spray Gray


Application

To apply on vehicle, ensure surface is clean and free of greases and oils. Paint must be air dried before putting on vehicle. Run at idle for 10 minutes. Cool for 20 minutes. Run at idle for 20 minutes, and let cool for 20 minutes. Run at normal operating temperature for 30 minuets, let cool for 30 minutes. Consult can label for specific curing procedures. DO NOT EXCEED TEMPERATURE OF THE LEAST HEAT TOLERANT COMPONENT OR BASE METAL.


Safety

Always wear eye, skin and respiratory protection. Always use in a well ventilated area away from open flame. Consult MSDS for specific safety precautions.


Warranty

Made in the USA


Application

To apply on vehicle, ensure surface is clean and free of greases and oils. Paint must be air dried before putting on vehicle. Run at idle for 10 minutes. Cool for 20 minutes. Run at idle for 20 minutes, let cool for 20 minutes. Run at normal operating temperature for 30 minuets, let cool for 30 minutes. Consult can label for specific curing procedures. DO NOT EXCEED TEMPERATURE OF THE LEAST HEAT TOLERANT COMPONENT OR BASE METAL.