30 Blind-Grip Holders hold sheet metal parts for final welding.
- Ideal prep for fabricating, riveting and welding
- Allows for proper alignment and fit
- For sheet metal or fiberglass panels
- Easy to use
Blind-grip holders are used by custom car builders to secure sheet metal parts. Work like your "third hand" to hold the two panels together while you rivet or weld.
Eastwood 19074A Compression Pliers are required to install and remove holders.
About Eastwood Blind Grip Holders 1/8in pack of 30
"We have all heard the old saying, 'If I only had three hands...' Well, here they are. This panel-holding system helped me earn a cool 20 grand on a complete resto of a ’66 Chevy pick-up. Eastwood has lots of cool tools, and best of all they work, and the warranty is great too. Something so simple, and yet it works so well...imagine that."
— Roger, New Tazewell, TN
30 Blind Holders
Drill a 1/8" hole through both panels and insert holder. Grip range is up to 1/4", with nearly 20 lbs. of holding power. Get our Side-Grip Fasteners (19083) for edge work.
Eastwood Offers Free Lifetime Technical Support
Attention California Residents - Proposition 65
WARNING - Cancer and Reproductive Harm - www.P65Warnings.ca.gov