10 Blind-Grip Holders hold sheet metal parts for final welding.
- Ideal prep for fabricating, riveting and welding
- Allows for proper alignment and fit
- For sheet metal or fiberglass panels
- Easy to use
Blind-grip holders are used by custom car builders to secure sheet metal parts. Work like your "third hand" to hold the two panels together while you rivet or weld.
Eastwood 19074A Compression Pliers are required to install and remove holders.
About Eastwood Blind Grip Panel Holders pack of 10
These handy blind holders are used by custom car builders to hold sheet metal parts before final welding. Very easy to use. Drill a 1/8" hole through both pieces and insert fastener. Each one provides nearly 20 lbs holding power and has a grip range of up to 1/4".
10 Blind Grip Holders
Eastwood Offers Free Lifetime Technical Support
Attention California Residents - Proposition 65
WARNING - Cancer and Reproductive Harm - www.P65Warnings.ca.gov