DO THE JOB RIGHT.
Details
Eastwood European Urethane Clearcoat plus Activator System makes 1-1/2 gallons of premium clearcoat
- Easy to spray flat, and even easier to polish
- Long-lasting protection from UV, chemicals and weathering
- High-solids content to build quickly and avoid shrink-back as it cures
- Approximate Coverage Per Gallon: 150 SQ FT
- Maximum operating temperature: 150 Fahrenheit
Eastwood Euro Urethane Clear is a premium 2:1, high-solids clearcoat made from superior European resins. It dries fast, with a beautiful gloss and excellent DOI. Flows and levels easily with no shrinkage or dieback. Features excellent durability and long-lasting UV protection, weathering and everyday wear. Includes 2 quarts Eastwood Low VOC Activator. Mixes 2:1, 2 parts clear, 1 part activator.
About Eastwood 2:1 Urethane Clear Gallon and Activators
Thoroughly mix two parts 50250ZP HS Clear in gallons or 50251ZP HS Clear in quarts, with one part 50252ZP HS Clear Activator. For even better spray-ability, 2:1 mix may be
reduced with a urethane-grade reducer or other appropriate solvent product. Doing this will improve the flow and leveling. Eastwood suggests using a Zero-VOC reducer to avoid potential compliance issues. Use caution in mixing materials as HS Clear may begin to gel after approximately two hours (at 70 °F). Apply Eastwood HS Clear in two medium wet coats, with a 10-minute flash period between each. Clear should be dry to the touch within 10 minutes, and will be tack-free within three hours (at 70 °F). Do not recoat between one and eight hours after previous coat. Additional coats may be applied after eight, but before 18 hours (at 70 °F) have passed from completion of previous coat. Ideal application temperature is between 70°F and 90°F. For increased depth and gloss, well cured clear may be wet sanded and recoated with one to two additional wet coats.
MIXING RATIO
SPRAY GUN SETUP
HVLP Gun
Fluid Tip 1.3-1.5 mm Inlet Spray Pressure 25-30 psi
Conventional Gravity
Fluid Tip 1.3-1.6 mm Inlet Spray Pressure 45-50 psi
Conventional Siphon
Fluid Tip: 1.4-1.8 mm Inlet Spray Pressure 45-50 psi
APPLICATION INSTRUCTIONS
Contents
Accessories
paint guns, tape, masking paper, wet sanding products, paint suits, respirators, mixing cups
Safety
Always wear eye, skin and respiratory protection when painting follow instructions on can label
Warranty
Made in USA
Product Video
Eastwood Offers Free Lifetime Technical Support
Click here for product SDS information
Attention California Residents - Proposition 65
WARNING - Cancer and Reproductive Harm - www.P65Warnings.ca.gov