Pot Life: Approximately 48 hours after button is pushed and can is activated.
Ideal application conditions:Temperature between 70-85 degrees F at 50% humidity or less.
Color: Gray

Contains 8.6oz/243 grams of Sprayable Primer Surfacer

Remove rust if necessary. Sand surface smooth and then clean with Eastwood PRE. Only apply on dry, dust free substrates. Before activating, shake can vigorously for 2 minutes. Next, take red button from cap and turn the can upside down to attach the button to pin on bottom of the can. With cap on, place the can upside down on a firm surface. Press red button with the ball of your hand until stops. Paint is now activated. Shake for 2 minutes before spraying. 2-5 spray passes will build a 4-28mil thickness dry film coating. Approximate can coverage is 2.7 sq. ft. at approximately 8 mil thickness.  Keep the nozzle 10 inches away from the substrate. 68-70°F: Allow 5-10 minutes of flash time between coats. Allow 1-2 hours drying time before sanding. When coating is fully cured, perform first round of sanding with P120-P180 sandpaper.  Once desired rough finish is achieved, finish sand with P240-P280 sand paper. Do not wet sand. Dry sand only. Once activated, this coating has about a 2-6 hour pot life. Higher temperatures can shorten the pot life as lower temperatures can extend pot life.

Always read and fully understand all safety warnings and instructions on the can before using this product. Always wear proper safety equipment when using this product.

Click here to see safety products